Difficulty

Moderate

Steps

8

Time Required

                          15 minutes

Sections

1

  • Speaker
  • 8 steps

Flags

0

  • BackBlu Dash 5.0 Dual SIM

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Speaker
  • Make sure device is disconnected and turned off.
  • Locate the groove at the bottom left corner of the phone.
  • Insert the plastic opening tool in the groove and pry it open.
  • Lift the back cover of the phone using your hands.

Make sure device is disconnected and turned off.

Locate the groove at the bottom left corner of the phone.

Insert the plastic opening tool in the groove and pry it open.

Lift the back cover of the phone using your hands.

1024

Step 2

  • Pry the battery out from the back of the phone using the plastic opening tool.

Pry the battery out from the back of the phone using the plastic opening tool.

Step 3

  • Remove the 12 screws located at the back panel of the phone using a J000 screwdriver.
  • The red circles are screw holes that hold the 3.5mm length Phillips screw.
  • The orange circles are screw holes that hold the 2.5mm length Phillips screw.

Remove the 12 screws located at the back panel of the phone using a J000 screwdriver.

The red circles are screw holes that hold the 3.5mm length Phillips screw.

The orange circles are screw holes that hold the 2.5mm length Phillips screw.

Step 4

  • Remove the back panel of the phone with your hand.
  • Carefully remove the plastic back panel to avoid breaking it.

Remove the back panel of the phone with your hand.

Carefully remove the plastic back panel to avoid breaking it.

Step 5

  • Remove the antenna cable connectors using a spudger.

Remove the antenna cable connectors using a spudger.

Step 6

  • Unscrew the 2.5mm screws from the circuit board holding the speaker at the bottom of the phone.

Unscrew the 2.5mm screws from the circuit board holding the speaker at the bottom of the phone.

Step 7

  • Flip the ZIF flap up with tweezers.
  • Remove the ribbon cable with tweezers.
  • The ribbon cable is sensitive and needs to be removed carefully to insure its integrity.

Flip the ZIF flap up with tweezers.

Remove the ribbon cable with tweezers.

The ribbon cable is sensitive and needs to be removed carefully to insure its integrity.

Step 8

  • Remove the speaker panel with the plastic opening tool.
  • The panel is glued onto the device and will require extra force to remove.

Remove the speaker panel with the plastic opening tool.

The panel is glued onto the device and will require extra force to remove.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Mukish Kumar Munyady

Member since: 01/30/2017

201 Reputation

                                      2 Guides authored                  



                       Badges:
                       3

Team

                       IUPUI, Team 1-1, Baechle Spring 2017                        

                                                  Member of IUPUI, Team 1-1, Baechle Spring 2017 



                    IUPUI-BAECHLE-S17S1G1                     


                                            4 Members                     


                                            3 Guides authored