Difficulty

Moderate

Steps

10

Time Required

                          30 minutes

Sections

2

  • Battery
  • 2 steps
  • Digitizer
  • 8 steps

Flags

0

  • BackBLU Dash JR D140

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Turn off the phone first. Press the power button continuously for 2-3 seconds to shut down the phone.
  • Using a plastic opening tool, pry open the back cover from the slit on the bottom right corner of the phone.

Turn off the phone first. Press the power button continuously for 2-3 seconds to shut down the phone.

Using a plastic opening tool, pry open the back cover from the slit on the bottom right corner of the phone.

1024

Step 2

  • Using a plastic opening tool or finger, pull out the battery.

Using a plastic opening tool or finger, pull out the battery.

Step 3

              Digitizer
  • Remove the four 4.0mm Phillips #1 screws.

Remove the four 4.0mm Phillips #1 screws.

Step 4

  • Starting from a corner, separate the panel from the frame using the plastic opening tool.
  • The volume button will pop out.

Starting from a corner, separate the panel from the frame using the plastic opening tool.

The volume button will pop out.

Step 5

  • Unscrew the 3.6mm Phillips #0 screw from the motherboard.

Unscrew the 3.6mm Phillips #0 screw from the motherboard.

Step 6

  • Using a spudger, lift the black ZIF connector at the top left corner of the phone.

Using a spudger, lift the black ZIF connector at the top left corner of the phone.

Step 7

  • Pull the ribbon cable out of the ZIF connector.

Pull the ribbon cable out of the ZIF connector.

Step 8

  • When the ribbon cable is removed from the ZIF connector, peel off the power, sticky button using a plastic opening tool.

When the ribbon cable is removed from the ZIF connector, peel off the power, sticky button using a plastic opening tool.

Step 9

  • Peel off the volume sticky button.

Peel off the volume sticky button.

Step 10

  • Separate the screen cover from the motherboard using the plastic opening tool. And don’t forget that your phone can mess up if u separate the motherboard from the screen cover
  • Make sure that the LCD screen stays attached to the motherboard while doing this.

Separate the screen cover from the motherboard using the plastic opening tool. And don’t forget that your phone can mess up if u separate the motherboard from the screen cover

Make sure that the LCD screen stays attached to the motherboard while doing this.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 6 other contributors 


                    Nathanael

Member since: 07/23/2015

233 Reputation

                                      1 Guide authored                  



                       Badges:
                       9







                                                        +6 more badges