Difficulty
Moderate
Steps
4
Time Required
15 minutes
Sections
2
- Battery
- 3 steps
- Vibration Motor
- 1 step
Flags
0
BackBLU Energy X
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Remove the back case using plastic opening tool.
Remove the back case using plastic opening tool.
1024
Step 2
- Remove the seven 4mm Phillips #000 screws.
- Remove the top plate.
Remove the seven 4mm Phillips #000 screws.
Remove the top plate.
Step 3
- Detach the battery from the mother board using a plastic opening tool.
- Use a plastic spudger to remove battery.
Detach the battery from the mother board using a plastic opening tool.
Use a plastic spudger to remove battery.
Step 4
Vibration Motor
- Remove the five 4 mm JIS J000 screws from bottom plate
- Using a soldering iron, simultaneously heat the two soldered connections for the motor
- When the connection is melted, use a set of tweezers to safely remove the motor
Remove the five 4 mm JIS J000 screws from bottom plate
Using a soldering iron, simultaneously heat the two soldered connections for the motor
When the connection is melted, use a set of tweezers to safely remove the motor
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 3 other contributors
Sishun Wang
Member since: 02/08/2016
630 Reputation
4 Guides authored
Badges:
10
+7 more badges
Team
USF Tampa, Team 12-2, Eyestone Spring 2016
Member of USF Tampa, Team 12-2, Eyestone Spring 2016
USFT-EYESTONE-S16S12G2
3 Members
5 Guides authored