Difficulty

Moderate

Steps

7

Time Required

                          10 - 20 minutes

Sections

3

  • Back Cover
  • 3 steps
  • Upper Plastic Plate/Antenna
  • 3 steps
  • Fingerprint Sensor
  • 1 step

Flags

1

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackBLU R2 Plus

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Power Off
  • Be sure that your BLU R2 Plus is completely powered off and has less than 25% battery left. This will lower the chance of your battery catching fire and your logic board/motherboard shorting out.

Be sure that your BLU R2 Plus is completely powered off and has less than 25% battery left. This will lower the chance of your battery catching fire and your logic board/motherboard shorting out.

1024

Step 2

              Releasing the Back Cover
  • Insert your pick in the top left-hand corner where the little indent is.
  • Slide the pick all the way around the phone until the back cover is loose and ready to be released.

Insert your pick in the top left-hand corner where the little indent is.

Slide the pick all the way around the phone until the back cover is loose and ready to be released.

Step 3

              Remove Back Cover
  • Remove the Back Cover to gain access to sim card trays, the memory card slot, or just to replace it.

Remove the Back Cover to gain access to sim card trays, the memory card slot, or just to replace it.

Step 4

              Tape the sticker
  • Use a plastic opening pick to peel up the sticker from the arms of both the upper and lower plastic plates on both sides of the battery. This will reveal screws to both plates.
  • To hold back the sticker, use small bits of tape.

Use a plastic opening pick to peel up the sticker from the arms of both the upper and lower plastic plates on both sides of the battery. This will reveal screws to both plates.

To hold back the sticker, use small bits of tape.

Step 5

              Unscrew Upper Plastic Plate
  • Use a Phillips #00 screwdriver to unscrew the nine screws from the upper plastic plate.

Use a Phillips #00 screwdriver to unscrew the nine screws from the upper plastic plate.

Step 6

              Upper Plate Removal
  • Using an opening pick to wedge under spaces around the upper plate, unclip the upper plate from the phone and slide it up and out.

Using an opening pick to wedge under spaces around the upper plate, unclip the upper plate from the phone and slide it up and out.

Step 7

              Fingerprint Sensor
  • Use tweezers to carefully pull up the fingerprint sensor from the upper plate.

Use tweezers to carefully pull up the fingerprint sensor from the upper plate.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Derek Thomas

Member since: 09/02/2021

692 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges