Difficulty
Moderate
Steps
9
Time Required
Suggest a time??
Sections
2
- Battery
- 2 steps
- Camera
- 7 steps
Flags
1
In Progress
This guide is a work in progress. Reload periodically to see the latest changes!
BackBLU Studio 5.5
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Battery
- Flip over your Studio 5.5 so the back is facing you.
- Use either the spudger or your fingernail to pull up on the slot in the lower left corner and remove the back cover.
Flip over your Studio 5.5 so the back is facing you.
Use either the spudger or your fingernail to pull up on the slot in the lower left corner and remove the back cover.
1024
Step 2
- Place your finger in the small groove beneath the battery.
- Push the battery toward the top of the phone and lift it out.
Place your finger in the small groove beneath the battery.
Push the battery toward the top of the phone and lift it out.
Step 3
Camera
- Begin by removing the 12 3.5mm screws along the back of the device.
- 1 of these screws will be underneath a white sticker. Just press the screwdriver through it and remove it normally.
Begin by removing the 12 3.5mm screws along the back of the device.
1 of these screws will be underneath a white sticker. Just press the screwdriver through it and remove it normally.
Step 4
- Using your plastic opening tool, begin carefully prying the plastic shell from the phone.
- Make your way around the edge slowly and lift the shell off when you have made a full circuit.
Using your plastic opening tool, begin carefully prying the plastic shell from the phone.
Make your way around the edge slowly and lift the shell off when you have made a full circuit.
Step 5
- Locate and unplug seven connectors on the motherboard.
- Those marked in red are pulled straight up, away from the phone.
- The connector marked in orange is pulled out horizontally.
Locate and unplug seven connectors on the motherboard.
Those marked in red are pulled straight up, away from the phone.
The connector marked in orange is pulled out horizontally.
Step 6
- Unscrew the three 3.5mm screws securing the motherboard in place.
Unscrew the three 3.5mm screws securing the motherboard in place.
Step 7
- Using the plastic opening tool, you can now lift the motherboard straight up and out.
Using the plastic opening tool, you can now lift the motherboard straight up and out.
Step 8
- Carefully wedge the plastic remover tool underneath the corner of the camera module and slowly pry until it comes free.
Carefully wedge the plastic remover tool underneath the corner of the camera module and slowly pry until it comes free.
Step 9
- Use tweezers to lift the camera module out, taking care not to get any fingerprints on it.
- During reassembly, make sure the ribbon attached to the camera goes up and through the square hole on the motherboard so it is able to reconnect properly.
Use tweezers to lift the camera module out, taking care not to get any fingerprints on it.
During reassembly, make sure the ribbon attached to the camera goes up and through the square hole on the motherboard so it is able to reconnect properly.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 2 other contributors
Brian Sullivan
Member since: 10/22/2014
647 Reputation
3 Guides authored
Badges:
8
+5 more badges
Team
UMass Dartmouth, Team 1-2, Shastany Fall 2014
Member of UMass Dartmouth, Team 1-2, Shastany Fall 2014
UMASSD-SHASTANY-F14S1G2
3 Members
3 Guides authored
