Difficulty
Moderate
Steps
6
Time Required
5 - 10 minutes
Sections
3
- Back Case
- 2 steps
- Frame Cover
- 2 steps
- Camera
- 2 steps
Flags
0
BackBLU WIN HD LTE
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Case
- Pry the back cover from the bottom of the phone, pulling outwards and upwards.
Pry the back cover from the bottom of the phone, pulling outwards and upwards.
1024
Step 2
- Fully remove the cover and set aside in a safe place.
Fully remove the cover and set aside in a safe place.
Step 3
Frame Cover
- Remove all the nine 2mm screws using the JIS #00 Screwdriver.
Remove all the nine 2mm screws using the JIS #00 Screwdriver.
Step 4
- Pry the frame off using the spudger pulling upwards going to different areas around the device.
- The back cover is secured by glue. Removal could be more difficult than expected.
Pry the frame off using the spudger pulling upwards going to different areas around the device.
The back cover is secured by glue. Removal could be more difficult than expected.
Step 5
Camera
- Pry off the low profile connector located on the right side of the camera device.
Pry off the low profile connector located on the right side of the camera device.
Step 6
- Pull the camera out.
Pull the camera out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Taelar Tritton-Bowman
Member since: 09/21/2018
249 Reputation
3 Guides authored
Badges:
5
+2 more badges
Team
University of North Texas, Team S5-G7, Thompson Fall 2018
Member of University of North Texas, Team S5-G7, Thompson Fall 2018
UNT-THOMPSON-F18S5G7
3 Members
5 Guides authored
