Difficulty

Easy

Steps

8

Time Required

                          5 minutes

Sections

1

  • Body Cover Removal
  • 8 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackPentax ZX-5n

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove back cover
  • Push down on the screw to depress the spring loaded hinge and release the door.

Push down on the screw to depress the spring loaded hinge and release the door.

1024

Step 2

              Remove bottom cover
  • Remove six 5.3 mm #00 screws.
  • Remove one 3.4 mm #00 screw.
  • The short screw has a machine thread and screws into the plate underneath. The rest screw into the plastic body.

Remove six 5.3 mm #00 screws.

Remove one 3.4 mm #00 screw.

The short screw has a machine thread and screws into the plate underneath. The rest screw into the plastic body.

Step 3

              Remove left front cover
  • Remove three 5.3 mm #00 screws (the bottom-most screw is not always present).
  • Remove one 7.3 mm #00 screw.
  • Remove the remote trigger cover.

Remove three 5.3 mm #00 screws (the bottom-most screw is not always present).

Remove one 7.3 mm #00 screw.

Remove the remote trigger cover.

Step 4

              Remove front cover
  • Remove one 3.4 mm #00 screw.
  • Remove two 5.3 mm #00 screw.
  • Gently lift up on the flash housing to help remove the cover if necessary.

Remove two 5.3 mm #00 screw.

Gently lift up on the flash housing to help remove the cover if necessary.

Step 5

              Remove right front cover
  • Remove two 3.9 mm #00 screws.

Remove two 3.9 mm #00 screws.

Step 6

              Remove eye cup
  • Slide the eye cup up and off to access the screws underneath.

Slide the eye cup up and off to access the screws underneath.

Step 7

              Unscrew top cover
  • Remove two 5.3 mm #00 screws by the eyepiece.
  • Remove one 6.8 mm #00 screw in the battery compartment.
  • Remove one 7.0 mm #00 screw near the take up spool.

Remove two 5.3 mm #00 screws by the eyepiece.

Remove one 6.8 mm #00 screw in the battery compartment.

Remove one 7.0 mm #00 screw near the take up spool.

Step 8

              Lift top cover
  • Lift the cover so it is just free of the body. It is still attached by several wires.

Lift the cover so it is just free of the body. It is still attached by several wires.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Sam Gustafson

Member since: 09/01/2022

1,210 Reputation

                                      8 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges