Difficulty
Moderate
Steps
7
Time Required
25 minutes
Sections
2
- Rear Wheels
- 4 steps
- Belts
- 3 steps
Flags
0
BackBoosted Board 1st Generation
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Rear Wheels
- Loosen the two 16.74 mm motor mount hex nut screws with a 9/64" Allen wrench.
- Do Not Remove the Screws.
Loosen the two 16.74 mm motor mount hex nut screws with a 9/64" Allen wrench.
Do Not Remove the Screws.
1024
Step 2
- Compress the motor mount back towards the wheel.
- While keeping the motor mount compressed, tighten one of the hex nuts that you loosened in the previous step.
- The motor mounts are spring tensioned so it is necessary compress them to loosen the belts.
Compress the motor mount back towards the wheel.
While keeping the motor mount compressed, tighten one of the hex nuts that you loosened in the previous step.
The motor mounts are spring tensioned so it is necessary compress them to loosen the belts.
Step 3
- Remove the axel nut with a 1/2" socket wrench
Remove the axel nut with a 1/2" socket wrench
Step 4
- Rotate and pull counterclockwise until the wheel comes off the axle completely.
- The front washer will come off with the wheel.
- Remove the back washer from the axle.
- Replacing the wheel requires the bearings to be switched into the new wheel.
Rotate and pull counterclockwise until the wheel comes off the axle completely.
The front washer will come off with the wheel.
Remove the back washer from the axle.
Replacing the wheel requires the bearings to be switched into the new wheel.
Step 5
Belts
- Compress the motor mount back .
- Slide the belt off the axle
Compress the motor mount back .
Slide the belt off the axle
Step 6
- Remove the two hex screws.
- Remove the front hex screw.
- When removing the Front hex screw, hold the motor mount and the truck together.
- The springs inside the motor mount will push the motor out of the casing if they are not held together.
Remove the two hex screws.
Remove the front hex screw.
When removing the Front hex screw, hold the motor mount and the truck together.
The springs inside the motor mount will push the motor out of the casing if they are not held together.
Step 7
- Making sure to hold the motor and truck together, lift off the belt casing and take off the belt.
- Do Not let go of the motor and truck until the new belt is on and the Front hex screw is tightened securely.
- The springs inside the motor mount will push the motor out of the casing if they are not held together.
Making sure to hold the motor and truck together, lift off the belt casing and take off the belt.
Do Not let go of the motor and truck until the new belt is on and the Front hex screw is tightened securely.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 4 other contributors
Emily Imfeld
Member since: 10/06/2016
514 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team 15-7, Livingston Fall 2016
Member of Cal Poly, Team 15-7, Livingston Fall 2016
CPSU-LIVINGSTON-F16S15G7
4 Members
6 Guides authored
