Difficulty
Moderate
Steps
3
Time Required
10 minutes
Sections
1
- Motor Brushes
- 3 steps
Flags
0
BackBosch 3727DEVS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Motor Brushes
- Ensure that the power chord is not plugged into an outlet.
- Using the T20 Torx Screwdriver, remove the four 15.6 mm screws securing the top cover to the sander.
- Lift the top cover off the sander.
Ensure that the power chord is not plugged into an outlet.
Using the T20 Torx Screwdriver, remove the four 15.6 mm screws securing the top cover to the sander.
Lift the top cover off the sander.
1024
Step 2
- Remove the two white wires connected to each motor brush by pulling on the spade terminals.
Remove the two white wires connected to each motor brush by pulling on the spade terminals.
Step 3
- Using the T10 Torx Screwdriver, remove the four 9.7 mm screws securing the motor brushes to the housing.
- After the screws are removed, both motor brushes can be lifted out of their position by hand.
Using the T10 Torx Screwdriver, remove the four 9.7 mm screws securing the motor brushes to the housing.
After the screws are removed, both motor brushes can be lifted out of their position by hand.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 4 other contributors
Daniel Riddle
Member since: 01/29/2016
331 Reputation
3 Guides authored
Badges:
6
+3 more badges
Team
Western Carolina University, Team 1-1, Virtue Spring 2016
Member of Western Carolina University, Team 1-1, Virtue Spring 2016
WCU-VIRTUE-S16S1G1
5 Members
5 Guides authored
