Difficulty
Moderate
Steps
3
Time Required
8 minutes
Sections
1
- Power Cord
- 3 steps
Flags
0
BackBosch 3727DEVS
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power Cord
- Ensure that the power chord is not plugged into an outlet.
- Using the T20 Torx Screwdriver, remove the four 15.6 mm screws securing the top cover to the sander.
- Lift the top cover off the sander.
Ensure that the power chord is not plugged into an outlet.
Using the T20 Torx Screwdriver, remove the four 15.6 mm screws securing the top cover to the sander.
Lift the top cover off the sander.
1024
Step 2
- Using the T20 Torx Screwdriver, remove the two 15.6 mm screws securing the cable clip to the motor housing.
- Lift cable clip and cord from motor housing.
Using the T20 Torx Screwdriver, remove the two 15.6 mm screws securing the cable clip to the motor housing.
Lift cable clip and cord from motor housing.
Step 3
- Using the 2.5 mm Flathead Screwdriver, loosen the two screws securing the white and black wires to the On/Off Switch.
Using the 2.5 mm Flathead Screwdriver, loosen the two screws securing the white and black wires to the On/Off Switch.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Daniel Riddle
Member since: 01/29/2016
331 Reputation
3 Guides authored
Badges:
6
+3 more badges
Team
Western Carolina University, Team 1-1, Virtue Spring 2016
Member of Western Carolina University, Team 1-1, Virtue Spring 2016
WCU-VIRTUE-S16S1G1
5 Members
5 Guides authored