Difficulty

Easy

Steps

10

Time Required

Suggest a time??

Sections

1

  • Opening
  • 10 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackBosch arriva 1500 W

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Opening
  • Remove the top cap, and any filters.

Remove the top cap, and any filters.

1024

Step 2

              Unscrew the body of the motor
  • There is only one screw to remove, at the back of the vacuum cleaner.
  • Put the screw in a safe place

There is only one screw to remove, at the back of the vacuum cleaner.

Put the screw in a safe place

Step 3

              Un clipping the body of the motor
  • Use a screwdriver to unclip the body of the motor. There are two clips in front and one on the side of the plug (towards the back).

Use a screwdriver to unclip the body of the motor. There are two clips in front and one on the side of the plug (towards the back).

Step 4

  • Remove the top of the body of the motor.

Remove the top of the body of the motor.

Step 5

              Removing on/off button
  • Remove the on/off button.

Remove the on/off button.

Step 6

              Removing electric plug coil
  • Slide the electric plug coil out of its rails.
  • For reassembling, see step 10.

Slide the electric plug coil out of its rails.

For reassembling, see step 10.

Step 7

  • Slide the electric circuit board out of the electric plug coil.

Slide the electric circuit board out of the electric plug coil.

Step 8

              Removing the motor
  • Lift out the motor.
  • Gently unwrap the fleece.

Lift out the motor.

Gently unwrap the fleece.

Step 9

              The motor
  • The motor is held in place by two rubber pieces on either side.
  • You may remove these rubber parts from the motor

The motor is held in place by two rubber pieces on either side.

You may remove these rubber parts from the motor

Step 10

              Reassembling step 6
  • Re-assemble in reverse order until step 6.
  • Slide the plug coil into its rails. Make sure that the coil is completely wrapped up around the wheel. Otherwise the spring in the wheel may be totally loose, and will not coil.
  • Carefully put the button into its hole. It should stick out over the little curved groove, over the wires. Check that it turns the dimmer and clicks the on-off push button.

Re-assemble in reverse order until step 6.

Slide the plug coil into its rails. Make sure that the coil is completely wrapped up around the wheel. Otherwise the spring in the wheel may be totally loose, and will not coil.

Carefully put the button into its hole. It should stick out over the little curved groove, over the wires. Check that it turns the dimmer and clicks the on-off push button.

To reassemble your device, follow these instructions in reverse order until step 6: reassembly of this step is shown in step 10.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Elisabeth Kvaalen

Member since: 08/06/2020

181 Reputation

                                      1 Guide authored                  



                       Badges:
                       1