Difficulty

Easy

Steps

4

Time Required

                          10 minutes

Sections

1

  • Bosch DisassembleTKA8SL1 Solitaire coffee maker thermos jug
  • 4 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackBosch TKA8SL1 Solitaire Coffee Maker

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

The glass container is under vacuum and can implode. Therefore, wear gloves and safety goggles when handling !

What you need

Step 1

              Remove the bottom
  • Turn the jug upside down
  • The black base is screwed into the housing. Unscrew to the left.
  • Reach into the jug while wearing a glove
  • Turn the jug upside down and carefully remove the glass body and place it with the opening on a soft surface. The fused nozzle used for pumping can break off easily.
  • The glass body is available as a spare part (part 00441154, approx. 22 EUR incl. seal)

Turn the jug upside down

The black base is screwed into the housing. Unscrew to the left.

Reach into the jug while wearing a glove

Turn the jug upside down and carefully remove the glass body and place it with the opening on a soft surface. The fused nozzle used for pumping can break off easily.

The glass body is available as a spare part (part 00441154, approx. 22 EUR incl. seal)

1024

Step 2

              Removal of the upper body
  • The seal is loosely inserted in the housing. It is usually the cause for to leak out of the thermos housing.
  • The seal is available as a spare part (00426033, approx. 5 EUR).
  • For further disassembly loosen the 3 Torx T10 screws (plastic thread ca 3.2 x 15)
  • Press on the black plastic point and pull apart the upper and lower part

The seal is loosely inserted in the housing. It is usually the cause for to leak out of the thermos housing.

The seal is available as a spare part (00426033, approx. 5 EUR).

For further disassembly loosen the 3 Torx T10 screws (plastic thread ca 3.2 x 15)

Press on the black plastic point and pull apart the upper and lower part

Step 3

              Remove the handle
  • The handle is attached to the housing with a PH2 screw.
  • If the handle is loose, tighten carefully so that the thread in the plastic does not tear out. The handle is not available as a spare part.

The handle is attached to the housing with a PH2 screw.

If the handle is loose, tighten carefully so that the thread in the plastic does not tear out. The handle is not available as a spare part.

Step 4

              Reassembly
  • Thoroughly clean or replace the gasket before reassembly.
  • Use a piece of foam between the base and the glass container to apply a little more pressure to the seal, without damaging the glass container

Thoroughly clean or replace the gasket before reassembly.

Use a piece of foam between the base and the glass container to apply a little more pressure to the seal, without damaging the glass container

Follow these steps in revere order to reassemble your device

Cancel: I did not complete this guide.

        oldturkey03 is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

oldturkey03

Author

                                      with 1 other contributor 


                    HowThingsWork

Member since: 07/21/2021

1,134 Reputation

                                      8 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges