Bosch Gks 190 Blade Guard Replacement Repair Guide

Difficulty

Very easy

Steps

5

Time Required

                          10 - 20 minutes            

Sections

1

• Blade Guard
• 5 steps

Flags

2

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackBosch GKS 190 Reparatur

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Safety first               

• Disconnect the saw from the power supply to avoid accidents.

Disconnect the saw from the power supply to avoid accidents.

1024

Step 2

              Loosening the saw blade               

• The Allen key on the saw can be used to loosen the saw blade lock. It’s under the handle.

The Allen key on the saw can be used to loosen the saw blade lock. It’s under the handle.

Step 3

              Removing the saw blade               

• After the saw blade locking washer has been removed, the saw blade can be easily lifted out. To do this, the blade guard must be opened.

After the saw blade locking washer has been removed, the saw blade can be easily lifted out. To do this, the blade guard must be opened.

Step 4

              Release the safety device of the blade guard               

• Below the saw blade is the silver flange bushing which is held in place by a locking ring.
• Lever out the locking ring slightly with a thin spatula and wind it out of the locking groove with your fingers.

Below the saw blade is the silver flange bushing which is held in place by a locking ring.

Lever out the locking ring slightly with a thin spatula and wind it out of the locking groove with your fingers.

Step 5

              Removing the blade guard               

• Now the flange bushing can simply be pulled off and the blade guard can simply be angled out and pulled off.

Now the flange bushing can simply be pulled off and the blade guard can simply be angled out and pulled off.

Follow the steps in reverse order to reassemble your device.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             


        oldturkey03 is helping us fix the world!      Want to contribute?      Start translating › 

Special thanks to these translators:

100%

oldturkey03

Author

                                      with 1 other contributor 

                    Norman Jaeckel                     

Member since: 11/17/2018

534 Reputation

                                      1 Guide authored                  



                       Badges:
                       10







                                                        +7 more badges