Bose Series 1 Or 2 Bluetooth Earpiece Battery Replacement Repair Guide

Difficulty

Easy

Steps

6

Time Required

                          30 minutes            

Sections

1

• Battery
• 6 steps

Flags

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

• BackBose Series 1 or 2 Bluetooth Earpiece

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Use a little hot air to soften the glue holding the two halves together. Then you can gently separate the halves.
• Beware applying too much heat over the speaker grill as it will start to sag if it gets too hot.

Use a little hot air to soften the glue holding the two halves together. Then you can gently separate the halves.

Beware applying too much heat over the speaker grill as it will start to sag if it gets too hot.

1024

Step 2

• Opposite end, do the same.
• The crack was already there, thankfully I didn’t make it worse. A little super glue fixed it.

Opposite end, do the same.

The crack was already there, thankfully I didn’t make it worse. A little super glue fixed it.

Step 3

• Note the existing battery placement.
• Note the old hot glue points.

Note the existing battery placement.

Note the old hot glue points.

Step 4

              Carefully desolder the two battery terminals.               

• Note polarity of terminals.
• Old battery size is 4.8 mm high, 12 mm wide, 21 mm long. .

Note polarity of terminals.

Old battery size is 4.8 mm high, 12 mm wide, 21 mm long. .

Step 5

              Install new battery               

• New battery is 5 mm High, 12 mm wide and 20 mm long. It fit nicely.
• Carefully solder new battery leads to correct polarity terminals on the circuit board.

New battery is 5 mm High, 12 mm wide and 20 mm long. It fit nicely.

Carefully solder new battery leads to correct polarity terminals on the circuit board.

Step 6

              Glue the case back together.               

• Place a small dab of hot glue at each end of the case.
• Gently snap the case back together .

Place a small dab of hot glue at each end of the case.

Gently snap the case back together .

Charge it up!

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    Mikee K                     

Member since: 07/22/2017

175 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges