Bose Solo 5 Sound Bar Indicator Light Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          30 minutes - 1 hour            

Sections

1

• Indicator Light
• 8 steps

Flags

Missed a Step

Oops! This guide is currently missing some important steps.

• BackBose Solo 5 Sound Bar

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Indicator Light               

• Lay the Bose Solo 5 on its side, with the speakers facing away from you. This orientation will result in the bottom of the speaker facing upwards.

Lay the Bose Solo 5 on its side, with the speakers facing away from you. This orientation will result in the bottom of the speaker facing upwards.

1024

Step 2

• Remove five 18.25mm screws with a Phillips #2 screw driver.

Remove five 18.25mm screws with a Phillips #2 screw driver.

Step 3

• Gently remove the gold plates and the snap connector from the circuit board by pulling it apart.

Gently remove the gold plates and the snap connector from the circuit board by pulling it apart.

Step 4

• Using the plastic opening tool, slightly lift the circuit board up and remove it from the housing.

Using the plastic opening tool, slightly lift the circuit board up and remove it from the housing.

Step 5

• Disconnect the cords running to the white connector by pulling upon the tab until it is disconnected completely.

Disconnect the cords running to the white connector by pulling upon the tab until it is disconnected completely.

Step 6

• Locate the two clear LED receptors and note that one has two prongs and the other has three prongs.

Locate the two clear LED receptors and note that one has two prongs and the other has three prongs.

Step 7

• Locate on the back of the control panel where it states LED 902, 903, 904, and 905.

Locate on the back of the control panel where it states LED 902, 903, 904, and 905.

Step 8

• If there is any debris located in these locations, use the spudger tool to thoroughly clean the area.

If there is any debris located in these locations, use the spudger tool to thoroughly clean the area.

To reassemble the sound bar, follow the steps listed above in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 6 other contributors 

                    Emma                     

Member since: 10/05/2018

500 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Sam Houston State, Team S15-G7, Blackburne Fall 2018                        

                                                  Member of Sam Houston State, Team S15-G7, Blackburne Fall 2018 



                    SHSU-BLACKBURNE-F18S15G7                     


                                            2 Members                     


                                            4 Guides authored