Bose Solo 5 Sound Bar Speaker Replacement Repair Guide

Difficulty

Easy

Steps

6

Time Required

                          15 - 20 minutes            

Sections

1

• Speaker
• 6 steps

Flags

0

• BackBose Solo 5 Sound Bar

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

The speakers in the Bose Solo 5 Sound Bar are responsible for producing quality audio. If a speaker is damaged, the audio coming from the sound bar might be distorted or impaired.

Before using the following guide, make sure that there isn’t any buildup of dirt, dust, or other debris that could possibly be inhibiting the audio. If this is the case, an ESD-safe brush or small dust blower usually can be used to remove the debris.

Prior to starting the guide, make sure to power off the device and remove it from connection to any sources of electricity.

What you need

Step 1

              Speaker               

• Lay Bose Solo 5 on its top side with the speakers facing away from you.

Lay Bose Solo 5 on its top side with the speakers facing away from you.

1024

Step 2

• Remove the two screws located at the outer edge of the backside with a Phillips head screwdriver.

Remove the two screws located at the outer edge of the backside with a Phillips head screwdriver.

Step 3

• Lay the speaker on its backside with the speakers facing up. Wedge the plastic opening tool into the crack where the protective wire screen meets the housing. Pry apart until you create enough room for your fingers.

Lay the speaker on its backside with the speakers facing up. Wedge the plastic opening tool into the crack where the protective wire screen meets the housing. Pry apart until you create enough room for your fingers.

Step 4

• Pull the screen gently away from the housing to reveal the two speakers with your fingers.

Pull the screen gently away from the housing to reveal the two speakers with your fingers.

Step 5

• Remove the 4 screws in each corner of the speaker to remove it from the housing.

Remove the 4 screws in each corner of the speaker to remove it from the housing.

Step 6

• Peel back the styrofoam on the speaker & disconnect the yellow & brown wires by sliding them off the receptor.

Peel back the styrofoam on the speaker & disconnect the yellow & brown wires by sliding them off the receptor.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                                      with 3 other contributors 

                    Chase Cooper                     

Member since: 10/09/2018

220 Reputation

                                      1 Guide authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       Sam Houston State, Team S15-G7, Blackburne Fall 2018                        

                                                  Member of Sam Houston State, Team S15-G7, Blackburne Fall 2018 



                    SHSU-BLACKBURNE-F18S15G7                     


                                            2 Members                     


                                            4 Guides authored                     

Saket Adhau - Dec 12, 2022

Reply

Well opening the case affect its original sound tuning or will it affect the performance ?