Difficulty

Moderate

Steps

7

Time Required

                          1 hour

Sections

1

  • Battery
  • 7 steps

Flags

2

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Member-Contributed Guide

An awesome member of our community made this guide. It is not managed by iFixit staff.

  • BackBose SoundLink Color II

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Battery
  • Start by pulling on the outer edges of the rubber part on the bottom of the enclosure.
  • Note that it will not detach completely from the enclosure.

Start by pulling on the outer edges of the rubber part on the bottom of the enclosure.

Note that it will not detach completely from the enclosure.

1024

Step 2

  • Pry between the black hard plastic base and the colored rubber casing of your speaker.
  • The bottom of the speaker unclips, and you have access to the rings that hold the colored envelope.

Pry between the black hard plastic base and the colored rubber casing of your speaker.

The bottom of the speaker unclips, and you have access to the rings that hold the colored envelope.

Step 3

  • Pull on the colored envelope, folding it on itself outwards.
  • By removing the cover, the protective foam of the microphone will be damaged, the water resistance will be impacted.

Pull on the colored envelope, folding it on itself outwards.

By removing the cover, the protective foam of the microphone will be damaged, the water resistance will be impacted.

Step 4

  • Remove the 7 screws on the back of the enclosure.
  • And you access the interior of the enclosure (the battery has already been replaced in the photo shown).

Remove the 7 screws on the back of the enclosure.

And you access the interior of the enclosure (the battery has already been replaced in the photo shown).

Step 5

  • Cleanly cut the foam and battery wrap.
  • The foam and the envelope will be used for reassembly (to avoid vibrations).
  • Be careful not to puncture the battery or it may catch fire.

Cleanly cut the foam and battery wrap.

The foam and the envelope will be used for reassembly (to avoid vibrations).

Be careful not to puncture the battery or it may catch fire.

Step 6

  • Unsolder the two legs of the battery and take out the battery.

Unsolder the two legs of the battery and take out the battery.

Step 7

  • Solder the new battery, and replace the envelope with the foam, holding everything with tape.
  • For reassembly, follow this guide in reverse order.

Solder the new battery, and replace the envelope with the foam, holding everything with tape.

For reassembly, follow this guide in reverse order.

To reassemble your device, follow the instructions in reverse order.

Cancel: I did not complete this guide.

        HelloMacOS is helping us fix the world!      Want to contribute?      Start translating ›

Special thanks to these translators:

100%

HelloMacOS

Author

                                      with 1 other contributor 


                    yellowjellyfish

Member since: 10/01/2021

146 Reputation

                                      1 Guide authored                  



                       Badges:
                       2