Difficulty
Difficult
Steps
9
Time Required
8 minutes
Sections
3
- Bose Soundlink II Cover Removal
- 2 steps
- Side Cover
- 3 steps
- Button Cover
- 4 steps
Flags
0
BackBose Soundlink II
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Bose Soundlink II Cover Removal
- Using a 2.5 mm hex wrench, remove the two 13 mm screws from the bottom of the speaker.
Using a 2.5 mm hex wrench, remove the two 13 mm screws from the bottom of the speaker.
1024
Step 2
- Push up on the back of the cover until it slides up slightly.
- Pull the cover up and away from the speaker backing.
Push up on the back of the cover until it slides up slightly.
Pull the cover up and away from the speaker backing.
Step 3
Side Cover
- Remove the black electrical tape in order to reveal the screws attaching the side cover to the main body of the speaker. These screws are on the base of the device.
Remove the black electrical tape in order to reveal the screws attaching the side cover to the main body of the speaker. These screws are on the base of the device.
Step 4
- Using the T-10 star tip screwdriver, remove the two 13 mm screws located on the bottom of the speaker on each side of the battery pack.
Using the T-10 star tip screwdriver, remove the two 13 mm screws located on the bottom of the speaker on each side of the battery pack.
Step 5
- Slide the silver side cover down toward the base of the speaker. The silver cover will come off easily.
Slide the silver side cover down toward the base of the speaker. The silver cover will come off easily.
Step 6
Button Cover
- Once the Bose Soundlink II Side Covers Removal has been completed, remove the two screws (13 mm) an inch below the buttons on the back of the speaker using the T-10 star tip screwdriver.
Once the Bose Soundlink II Side Covers Removal has been completed, remove the two screws (13 mm) an inch below the buttons on the back of the speaker using the T-10 star tip screwdriver.
Step 7
- Using a tool such as a spudger or plastic opening tool, insert the end into one of the small indentations located on the back of the speaker. Start either on the indentation farthest to the right or to the left.
- Pry up with the spudger or plastic opening tool so that the cover is pushed up slightly.
Using a tool such as a spudger or plastic opening tool, insert the end into one of the small indentations located on the back of the speaker. Start either on the indentation farthest to the right or to the left.
Pry up with the spudger or plastic opening tool so that the cover is pushed up slightly.
Step 8
- Repeat this process with each of the indentations, working your way left or right (depending on where you start).
Repeat this process with each of the indentations, working your way left or right (depending on where you start).
Step 9
- Pull the cover around the buttons off. If you’d like, you can remove the button cover as well.
Pull the cover around the buttons off. If you’d like, you can remove the button cover as well.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 2 other contributors
John P Loughran
Member since: 03/02/2017
448 Reputation
3 Guides authored
Badges:
10
+7 more badges
Team
IUPUI, Team S3-G3, Harley Spring 2017
Member of IUPUI, Team S3-G3, Harley Spring 2017
IUPUI-HARLEY-S17S3G3
4 Members
3 Guides authored
