Difficulty
Moderate
Steps
6
Time Required
15 - 30 minutes
Sections
1
- Thermal Fuse
- 6 steps
Flags
Featured Student Guide
This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.
BackBourgini Panini Grill Deluxe
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Thermal Fuse
- Unplug your device before proceeding with the disassembly.
- Place the toaster upside down and remove the two Phillips screws on either side of the handlebar.
- Remove the two Phillips screws under the handlebar.
- Remove the handlebar from the toaster.
Unplug your device before proceeding with the disassembly.
Place the toaster upside down and remove the two Phillips screws on either side of the handlebar.
Remove the two Phillips screws under the handlebar.
Remove the handlebar from the toaster.
1024
Step 2
- Remove the 4 Phillips screws connecting the bottom housing of the grill to the heating element.
- Remove the 2 triangle screws connecting the cable cover to the bottom of the grill.
- Remove the cable cover.
Remove the 4 Phillips screws connecting the bottom housing of the grill to the heating element.
Remove the 2 triangle screws connecting the cable cover to the bottom of the grill.
Remove the cable cover.
Step 3
- Loosen the wire connectors by gently squeezing them with the pliers.
- Pull the cables out of the wire connectors.
- Don’t use force while pulling out the wires. If you cant get the cables out, try to squeeze the connectors again with the pliers.
- Lift up and remove the bottom of the grill.
Loosen the wire connectors by gently squeezing them with the pliers.
Pull the cables out of the wire connectors.
Don’t use force while pulling out the wires. If you cant get the cables out, try to squeeze the connectors again with the pliers.
Lift up and remove the bottom of the grill.
Step 4
- Simultanously press down the clip and pull the red wire to disconnect the red wire from the heating element.
- Gently pull the red cable including the heat resistant tube out of the cable holder.
Simultanously press down the clip and pull the red wire to disconnect the red wire from the heating element.
Gently pull the red cable including the heat resistant tube out of the cable holder.
Step 5
- Pull the heat resistant tube off of the thermal fuse.
- Cut the wire on both ends of the thermal fuse.
Pull the heat resistant tube off of the thermal fuse.
Cut the wire on both ends of the thermal fuse.
Step 6
- Put both ends of the cable and the thermal fuse into the connection tube.
- Squeeze the connection tube tight using the pliers (make sure the cables are not able to disconnect from the connection tube).
- Do the same thing on the other end of the thermal fuse.
Put both ends of the cable and the thermal fuse into the connection tube.
Squeeze the connection tube tight using the pliers (make sure the cables are not able to disconnect from the connection tube).
Do the same thing on the other end of the thermal fuse.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 1 other contributor
Team 2
Member since: 03/08/2017
101 Reputation
1 Guide authored
Badges:
3
Team
Delft University of Technology, Team S1-G2, Flipsen Spring 2017
Member of Delft University of Technology, Team S1-G2, Flipsen Spring 2017
TUD-FLIPSEN-S17S1G2
3 Members
1 Guide authored
