Bowers And Wilkins T7 Access Panel Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 minutes

Sections

Access Panel
5 steps

Flags

BackBowers and Wilkins T7
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Access Panel

As with all electronic devices, make sure your device is powered off before you begin.
Gently lift up the access panel; it should easily “pop” open.

As with all electronic devices, make sure your device is powered off before you begin.

Gently lift up the access panel; it should easily “pop” open.

1024

Step 2

Remove 14mm screws on the front panel with a J1 Phillips head screwdriver.
There are 8 screws in total.

Remove 14mm screws on the front panel with a J1 Phillips head screwdriver.

There are 8 screws in total.

Step 3

Be gentle, the rubber seal is fragile and easy to tear, resulting in cosmetic damage to your device.
Using the ifixit Opening Tool, carefully pry off the rubber seal around the sides.
The seal is held by adhesive, if this is proving difficult you can use a heat gun to help the process.

Be gentle, the rubber seal is fragile and easy to tear, resulting in cosmetic damage to your device.

Using the ifixit Opening Tool, carefully pry off the rubber seal around the sides.

The seal is held by adhesive, if this is proving difficult you can use a heat gun to help the process.

Step 4

The cover is the most difficult part to remove. As you work, pry continuously, moving the tool around the device, working it a little further as you go.
Using the ifixit Opening Tool, pry open at the seam found under the rubber seal.
As the cover starts to come off, you can lift up using your hand.

The cover is the most difficult part to remove. As you work, pry continuously, moving the tool around the device, working it a little further as you go.

Using the ifixit Opening Tool, pry open at the seam found under the rubber seal.

As the cover starts to come off, you can lift up using your hand.

Step 5

Gently squeeze the internal locking mechanism inside the red and white terminals with either your fingers or a pair of precision tweezers.
While squeezing the internal locking mechanism, pull back the terminal.
Repeat this process for the second speaker.

Gently squeeze the internal locking mechanism inside the red and white terminals with either your fingers or a pair of precision tweezers.

While squeezing the internal locking mechanism, pull back the terminal.

Repeat this process for the second speaker.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 3 other contributors

                    Shane R. Cowper

Member since: 03/02/2017

131 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       USF Tampa, Team S7-G1, Cagle Spring 2017                        

                                                  Member of USF Tampa, Team S7-G1, Cagle Spring 2017 



                    USFT-CAGLE-S17S7G1                     


                                            5 Members                     


                                            4 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team