Difficulty

Moderate

Steps

7

Time Required

                          30 - 45 minutes

Sections

1

  • Battery
  • 7 steps

Flags

0

  • BackBraun 5514

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Remove any attached trimmer heads by gripping and pulling away from the body.

Remove any attached trimmer heads by gripping and pulling away from the body.

1024

Step 2

  • Insert an opening pick between the top plate and the grey separator.
  • Slide the opening pick around the perimeter of the plate to release the hidden clips.

Insert an opening pick between the top plate and the grey separator.

Slide the opening pick around the perimeter of the plate to release the hidden clips.

Step 3

  • Remove the four 7.0mm Torx T6 screws attaching the grey plastic frame to the black plastic casing.

Remove the four 7.0mm Torx T6 screws attaching the grey plastic frame to the black plastic casing.

Step 4

  • Use the opening pick to lift the grey frame from the black casing.

Use the opening pick to lift the grey frame from the black casing.

Step 5

  • Remove the circuit board assembly from the frame.

Remove the circuit board assembly from the frame.

Step 6

  • Pull the small black plastic piece out of the frame.

Pull the small black plastic piece out of the frame.

Step 7

  • Desolder the four tabs connecting the batteries to the circuit board.
  • Repeat for the other side of the battery.

Desolder the four tabs connecting the batteries to the circuit board.

Repeat for the other side of the battery.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      16 other people completed this guide.

Author

                                      with 2 other contributors 


                    Andrew Kluckhuhn

Member since: 07/05/2018

815 Reputation

                                      2 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       IUPUI, Team S2-G2, Harley Summer 2018                        

                                                  Member of IUPUI, Team S2-G2, Harley Summer 2018 



                    IUPUI-HARLEY-SU18S2G2                     


                                            4 Members                     


                                            5 Guides authored

Casper Smit - Dec 19, 2020

Reply

What is the name/part nr. of the battery?

Lucas B - Apr 18, 2021

Reply

Thanks!

This manual is applicable for the model 5516, too :-)

The battery type should be: AAA 1000 mAh; make sure, to choose batteries, that are prepared for soldering!!

Yordan Chanev - May 4, 2021

Reply

Same goes for 5515.

Thanks for the guide :)

Mariusz Lewicki - Jan 6, 2022

Reply

Thanks, I was looking how to take apart 5513, similar enough, as far as the battery replacement goes, any rechargeable AAA battery should do. Batteries don’t like the heat from soldering iron, there are kits for welding batteries, another idea is to get cheap battery holder if you can fit it in.

Jhon Jones - Jan 20, 2022

Reply

Does the 1.2V Ni-MH AAA 1000mAh battery work, have an older model MGK5280 ?

Thanks.