Difficulty

Moderate

Steps

10

Time Required

                          15 minutes

Sections

1

  • Braun hld6 Disassembly
  • 10 steps

Flags

0

  • BackBraun HLD6

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Braun hld6 Disassembly
  • Make sure the hairdryer is not plugged in!
  • Take out the two 32.3 mm Phillips #1 screws from the outside.
  • Take out the one 6.0 mm Phillips #1 screw.

Make sure the hairdryer is not plugged in!

Take out the two 32.3 mm Phillips #1 screws from the outside.

Take out the one 6.0 mm Phillips #1 screw.

1024

Step 2

  • Pry apart the two main bodies.

Pry apart the two main bodies.

Step 3

  • Take out the last outside screw, a 6.0 mm PH #1, to remove the grid.

Take out the last outside screw, a 6.0 mm PH #1, to remove the grid.

Step 4

  • Take out the 14.6 mm Flathead screws that hold the power cord in place.
  • Take out the 18.2 mm Flathead screws that hold the buttons in place.
  • Take out the 27.1 mm Flathead screws that keep the motor in place.

Take out the 14.6 mm Flathead screws that hold the power cord in place.

Take out the 18.2 mm Flathead screws that hold the buttons in place.

Take out the 27.1 mm Flathead screws that keep the motor in place.

Step 5

  • Take out the interior.

Take out the interior.

Step 6

  • Loosen the 2 flathead screws in the terminal block closest to the power cord.
  • Pull out the power cord.

Loosen the 2 flathead screws in the terminal block closest to the power cord.

Pull out the power cord.

Step 7

  • Loosen the flathead screws and remove the wires from the button holder. Remove the button holders. When you unscrew the wire opposite to where the yellow wire is connected, you can slide the button off of the middle wire connected to the motor.

Loosen the flathead screws and remove the wires from the button holder. Remove the button holders. When you unscrew the wire opposite to where the yellow wire is connected, you can slide the button off of the middle wire connected to the motor.

Step 8

  • Lastly, remove the yellow wire.

Lastly, remove the yellow wire.

Step 9

  • Take out the diode.

Take out the diode.

Step 10

  • Remove the flathead screws from the back of the motor.
  • To take apart the remaining parts, desoldering is required.

Remove the flathead screws from the back of the motor.

To take apart the remaining parts, desoldering is required.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Roisin

Member since: 03/07/2018

181 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       Delft University of Technology, Team S1-G6, Flipsen Spring 2018                        

                                                  Member of Delft University of Technology, Team S1-G6, Flipsen Spring 2018 



                    TUD-FLIPSEN-S18S1G6                     


                                            5 Members                     


                                            1 Guide authored