Difficulty
Difficult
Steps
6
Time Required
15 minutes
Sections
1
- Charging base wire harness
- 6 steps
Flags
0
BackBraun Series 7 790cc
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Charging base wire harness
- Remove the cleaner cartridge from the charging base.
Remove the cleaner cartridge from the charging base.
1024
Step 2
- Depress the 4 tabs while lightly pulling the cover from the base.
- Next, depress the 2 molded tabs while still pulling the cover from the base.
Depress the 4 tabs while lightly pulling the cover from the base.
Next, depress the 2 molded tabs while still pulling the cover from the base.
Step 3
- Press inward on the side charging port while pulling cover from the base to separate.
Press inward on the side charging port while pulling cover from the base to separate.
Step 4
- Remove side charging port by prying tabs outward and rotating port upward.
Remove side charging port by prying tabs outward and rotating port upward.
Step 5
- Remove charging terminals by inserting a spudger from bottom the and sliding terminals up.
Remove charging terminals by inserting a spudger from bottom the and sliding terminals up.
Step 6
- Remove solder from circuit board and remove charging harness.
Remove solder from circuit board and remove charging harness.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
Ian Hayes
Member since: 11/07/2017
198 Reputation
2 Guides authored
Badges:
6
+3 more badges
Team
IUPUI, Team S3-G6, Harley Fall 2017
Member of IUPUI, Team S3-G6, Harley Fall 2017
IUPUI-HARLEY-F17S3G6
3 Members
5 Guides authored
