Braven Brv 1M Motherboard Replacement Repair Guide

Difficulty

Difficult

Steps

8

Time Required

                          25 - 30 minutes            

Sections

2

• Outer Casing
• 4 steps
• Motherboard
• 4 steps

Flags

0

• BackBraven BRV-1M

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Outer Casing               

• To remove the outer casing, use a 3mm Hex bit to remove the 4 large 12mm Hex screws on both sides of the device.

To remove the outer casing, use a 3mm Hex bit to remove the 4 large 12mm Hex screws on both sides of the device.

1024

Step 2

• Using the Metal Spudger, carefully pry each side of the rubber casing away from the device.
• A little resistance should be felt, but not enough to bend the spudger.

Using the Metal Spudger, carefully pry each side of the rubber casing away from the device.

A little resistance should be felt, but not enough to bend the spudger.

Step 3

• To remove the inner plastic casing, use a Phillips #00 head bit to remove the 16 small 9mm screws surrounding the top side of the device.

To remove the inner plastic casing, use a Phillips #00 head bit to remove the 16 small 9mm screws surrounding the top side of the device.

Step 4

• Carefully lift away the housing and replace the broken casing/component. Replace using the new casing.

Carefully lift away the housing and replace the broken casing/component. Replace using the new casing.

Step 5

              Motherboard               

• To remove the motherboard, proceed to unscrew the 3 Phillips #00 bit type, 13mm long screws located on both sides of the motherboard.

To remove the motherboard, proceed to unscrew the 3 Phillips #00 bit type, 13mm long screws located on both sides of the motherboard.

Step 6

• Then, proceed to unscrew the 5 Phillips #00 bit type, 9mm long screws located on the face of the charging dock.

Then, proceed to unscrew the 5 Phillips #00 bit type, 9mm long screws located on the face of the charging dock.

Step 7

• Disconnect the two 4-pin auxiliary button register cables connected on both sides of the motherboard.

Disconnect the two 4-pin auxiliary button register cables connected on both sides of the motherboard.

Step 8

• Once disconnected, carefully remove the motherboard by pulling upwards.

Once disconnected, carefully remove the motherboard by pulling upwards.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Erik Oliva                     

Member since: 02/14/2018

607 Reputation

                                      6 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge                           

Team

                       USF Tampa, Team S2-G1, Eyestone Spring 2018                        

                                                  Member of USF Tampa, Team S2-G1, Eyestone Spring 2018 



                    USFT-EYESTONE-S18S2G1                     


                                            4 Members                     


                                            6 Guides authored                     

anonymous 5979 - Nov 16, 2018

Reply

i need to eletric scheme!