Difficulty

Moderate

Steps

11

Time Required

                          25 minutes

Sections

4

  • Antenna
  • 2 steps
  • Top Cover
  • 3 steps
  • Motherboard
  • 5 steps
  • Battery
  • 1 step

Flags

0

  • BackBRCK v1

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Antenna
  • Stand the device on its side so the antenna is sitting on the top.

Stand the device on its side so the antenna is sitting on the top.

1024

Step 2

  • Use the tweezers to grip the neck of the antenna(the part closest to the device).
  • Use opposite hand to twist off the body of the antenna.

Use the tweezers to grip the neck of the antenna(the part closest to the device).

Use opposite hand to twist off the body of the antenna.

Step 3

              Top Cover
  • Place the face of the device showing BRCK face up.

Place the face of the device showing BRCK face up.

Step 4

  • Remove the four screws(4mm hex head) on the corners of the device with a Hex 2.0 Screwdriver.

Remove the four screws(4mm hex head) on the corners of the device with a Hex 2.0 Screwdriver.

Step 5

  • Remove the top cover.

Remove the top cover.

Step 6

              Motherboard
  • Remove the nut and washer from the RF connector, located where the antenna was connected.

Remove the nut and washer from the RF connector, located where the antenna was connected.

Step 7

  • Unplug the red, black, and yellow wire connection by lifting up.

Unplug the red, black, and yellow wire connection by lifting up.

Step 8

  • Carefully insert tweezers under the black tab, and lift to release the clip.
  • Slide the ribbon out from under the clip to free the motherboard.

Carefully insert tweezers under the black tab, and lift to release the clip.

Slide the ribbon out from under the clip to free the motherboard.

Step 9

  • Remove outside rubber covers by lifting them out of place.

Remove outside rubber covers by lifting them out of place.

Step 10

  • Slowly lift the motherboard out from the device by lifting it from the end next to the ribbon connection.
  • Lift and pull out of place.

Slowly lift the motherboard out from the device by lifting it from the end next to the ribbon connection.

Lift and pull out of place.

Step 11

              Battery
  • Flip device upside down. Hold the device and tap into your other hand with varying force to remove battery.
  • This may take a few tries to remove the battery.

Flip device upside down. Hold the device and tap into your other hand with varying force to remove battery.

This may take a few tries to remove the battery.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Jeret Buerger

Member since: 04/01/2015

501 Reputation

                                      5 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       Cal Poly, Team 12-3, Lancaster Spring 2015                        

                                                  Member of Cal Poly, Team 12-3, Lancaster Spring 2015 



                    CPSU-LANCASTER-S15S12G3                     


                                            3 Members                     


                                            14 Guides authored