Brentwood Ts 292B Heating Wire Replacement Repair Guide

Difficulty

Moderate

Steps

4

Time Required

                          25 minutes            

Sections

1

• Heating Wire
• 4 steps

Flags

In Progress

This guide is a work in progress. Reload periodically to see the latest changes!

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missed a Step

Oops! This guide is currently missing some important steps.

• BackBrentwood TS-292B

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Heating Wire               

• Remove the five screws to loosen the the outer housing from the internal components.
• Pull up on the black plastic housing until it is dislodged from the base.

Remove the five screws to loosen the the outer housing from the internal components.

Pull up on the black plastic housing until it is dislodged from the base.

1024

Step 2

• You will need to remove the toasting lever by removing the black tab from the lever.
• You will now be able to completely remove the housing from the base of the toaster.

You will need to remove the toasting lever by removing the black tab from the lever.

You will now be able to completely remove the housing from the base of the toaster.

Step 3

• You will need small chain nose pliers to check for slack on either end of the broken wire.
• If there is no slack in the wire, you must buy extra nichrome wire in order to fix your toaster.

You will need small chain nose pliers to check for slack on either end of the broken wire.

If there is no slack in the wire, you must buy extra nichrome wire in order to fix your toaster.

Step 4

• Pull the slack out of the wire and pinch the two ends of the wire together.
• Gently twist the two ends of the wires together to establish a connection.
• Disclaimer: The wires are flat so you will require extra wire if you are not able to obtain enough slack.

Pull the slack out of the wire and pinch the two ends of the wire together.

Gently twist the two ends of the wires together to establish a connection.

Disclaimer: The wires are flat so you will require extra wire if you are not able to obtain enough slack.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Elly Ayala                     

Member since: 09/21/2018

739 Reputation

                                      5 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges                           

Team

                       University of North Texas, Team S8-G7, Riccardelli Fall 2018                        

                                                  Member of University of North Texas, Team S8-G7, Riccardelli Fall 2018 



                    UNT-RICCARDELLI-F18S8G7                     


                                            4 Members                     


                                            5 Guides authored