Difficulty

Difficult

Steps

8

Time Required

                          50 minutes

Sections

3

  • Outer Shell
  • 4 steps
  • Motherboard Removal
  • 2 steps
  • Battery Charging Port
  • 2 steps

Flags

0

  • BackBrightsign 4k

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Tech Tip: this Replacement guide will require the use of a soldering iron to remove solders, so check out the soldering guide if you’re unfamiliar with the process.

What you need

Step 1

              Outer Shell
  • Remove three 8mm screws from the left side of the device.
  • Remove four 8mm screws from the right side of the device.

Remove three 8mm screws from the left side of the device.

Remove four 8mm screws from the right side of the device.

1024

Step 2

  • Apply pressure on the SD card to pop it out of the port.
  • Remove the card by pulling it out.

Apply pressure on the SD card to pop it out of the port.

Remove the card by pulling it out.

Step 3

  • Press down on the top cover of the device and slid it towards you until you see a slight gap created.
  • Lift the top cover off.

Press down on the top cover of the device and slid it towards you until you see a slight gap created.

Lift the top cover off.

Step 4

  • Slide the body case back away from the bottom.
  • Pull up the body case to remove it from the bottom.

Slide the body case back away from the bottom.

Pull up the body case to remove it from the bottom.

Step 5

              Motherboard Removal
  • Remove the four 8mm screws at each corner of the motherboard with a JIS #0 screwdriver.

Remove the four 8mm screws at each corner of the motherboard with a JIS #0 screwdriver.

Step 6

  • Lift the motherboard out of the casing.

Lift the motherboard out of the casing.

Step 7

              Battery Charging Port
  • Flip the motherboard over so the heatsink is facing down.
  • Desolder the four solder joints and remove the melted solder with the pump.

Flip the motherboard over so the heatsink is facing down.

Desolder the four solder joints and remove the melted solder with the pump.

Step 8

  • Apply the desoldering pump to remove the melted part from the motherboard (press the button to release it).
  • Using the tweezers apply pressure to the spade head clip shown.
  • Remove the charging port by pulling the piece off.

Apply the desoldering pump to remove the melted part from the motherboard (press the button to release it).

Using the tweezers apply pressure to the spade head clip shown.

Remove the charging port by pulling the piece off.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 


                    Nhi Pham

Member since: 02/15/2018

169 Reputation

                                      2 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       USF Tampa, Team S17-G6, Boczar Spring 2018                        

                                                  Member of USF Tampa, Team S17-G6, Boczar Spring 2018 



                    USFT-BOCZAR-S18S17G6                     


                                            4 Members                     


                                            6 Guides authored