Difficulty

Moderate

Steps

8

Time Required

                          25 - 45 minutes

Sections

3

  • Outer Shell
  • 4 steps
  • Motherboard Removal
  • 2 steps
  • Heat Sink
  • 2 steps

Flags

0

  • BackBrightsign 4k

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Outer Shell
  • Remove three 8mm screws from the left side of the device.
  • Remove four 8mm screws from the right side of the device.

Remove three 8mm screws from the left side of the device.

Remove four 8mm screws from the right side of the device.

1024

Step 2

  • Apply pressure on the SD card to pop it out of the port.
  • Remove the card by pulling it out.

Apply pressure on the SD card to pop it out of the port.

Remove the card by pulling it out.

Step 3

  • Press down on the top cover of the device and slid it towards you until you see a slight gap created.
  • Lift the top cover off.

Press down on the top cover of the device and slid it towards you until you see a slight gap created.

Lift the top cover off.

Step 4

  • Slide the body case back away from the bottom.
  • Pull up the body case to remove it from the bottom.

Slide the body case back away from the bottom.

Pull up the body case to remove it from the bottom.

Step 5

              Motherboard Removal
  • Remove the four 8mm screws at each corner of the motherboard with a JIS #0 screwdriver.

Remove the four 8mm screws at each corner of the motherboard with a JIS #0 screwdriver.

Step 6

  • Lift the motherboard out of the casing.

Lift the motherboard out of the casing.

Step 7

              Heat Sink
  • Flip the motherboard upside down.

Flip the motherboard upside down.

Step 8

  • Remove the black adhesive that covers the four screws.
  • Remove the four screws.
  • Flip the motherboard over and remove the heat sink by pulling up.

Remove the black adhesive that covers the four screws.

Remove the four screws.

Flip the motherboard over and remove the heat sink by pulling up.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Mattison Collins

Member since: 02/15/2018

85 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       USF Tampa, Team S17-G6, Boczar Spring 2018                        

                                                  Member of USF Tampa, Team S17-G6, Boczar Spring 2018 



                    USFT-BOCZAR-S18S17G6                     


                                            4 Members                     


                                            6 Guides authored