Difficulty
Moderate
Steps
6
Time Required
15 minutes
Sections
2
- Outer Shell
- 4 steps
- Motherboard Removal
- 2 steps
Flags
0
BackBrightsign 4k
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Outer Shell
- Remove three 8mm screws from the left side of the device.
- Remove four 8mm screws from the right side of the device.
Remove three 8mm screws from the left side of the device.
Remove four 8mm screws from the right side of the device.
1024
Step 2
- Apply pressure on the SD card to pop it out of the port.
- Remove the card by pulling it out.
Apply pressure on the SD card to pop it out of the port.
Remove the card by pulling it out.
Step 3
- Press down on the top cover of the device and slid it towards you until you see a slight gap created.
- Lift the top cover off.
Press down on the top cover of the device and slid it towards you until you see a slight gap created.
Lift the top cover off.
Step 4
- Slide the body case back away from the bottom.
- Pull up the body case to remove it from the bottom.
Slide the body case back away from the bottom.
Pull up the body case to remove it from the bottom.
Step 5
Motherboard Removal
- Remove the four 8mm screws at each corner of the motherboard with a JIS #0 screwdriver.
Remove the four 8mm screws at each corner of the motherboard with a JIS #0 screwdriver.
Step 6
- Lift the motherboard out of the casing.
Lift the motherboard out of the casing.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Zackery
Member since: 02/15/2018
347 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
USF Tampa, Team S17-G6, Boczar Spring 2018
Member of USF Tampa, Team S17-G6, Boczar Spring 2018
USFT-BOCZAR-S18S17G6
4 Members
6 Guides authored
