Difficulty

Very easy

Steps

7

Time Required

                          5 minutes

Sections

1

  • Filter and Light
  • 7 steps

Flags

0

  • BackKitchen Appliance

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Long-term use of an oven hood can cause the quality of parts to deteriorate, in turn causing them not to work as effectively. This is very common and only requires you to replace a few of the worn-out parts, namely the oven hood light and filter.

Prior to starting the guide, make sure that the oven under the hood has been turned off for a significant time to ensure a minimal chance of injury. Never handle hot lightbulbs.

This guide requires little to no technical experience with kitchen appliances, and can all be done by hand.

What you need

Step 1

              Filter and Light
  • Make sure the fan switch is centered, and the light switch is set to “off” to avoid any injuries.

Make sure the fan switch is centered, and the light switch is set to “off” to avoid any injuries.

1024

Step 2

  • Squeeze both ends of the bulb cover to pop it out of the slots.

Squeeze both ends of the bulb cover to pop it out of the slots.

Step 3

  • Make sure the lightbulb is cool before handling to avoid burns.
  • Unscrew and remove the lightbulb by turning it counterclockwise.

Make sure the lightbulb is cool before handling to avoid burns.

Unscrew and remove the lightbulb by turning it counterclockwise.

Step 4

  • Twist the latch above the filter clockwise.
  • Slide the filter out by gently pulling it.

Twist the latch above the filter clockwise.

Slide the filter out by gently pulling it.

Step 5

  • Insert the new filter.
  • Rotate the retaining latch counterclockwise to secure the filter.

Insert the new filter.

Rotate the retaining latch counterclockwise to secure the filter.

Step 6

  • Install the new lightbulb and turn it clockwise.

Install the new lightbulb and turn it clockwise.

Step 7

  • Reinsert the lightbulb cover by pressing both sides and fitting the cover’s tabs into the slots.

Reinsert the lightbulb cover by pressing both sides and fitting the cover’s tabs into the slots.

Your range hood is good-to-go!

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Mahdi M

Member since: 01/17/2022

145 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       York University, Team P-21, O'Regan Winter 2022                        

                                                  Member of York University, Team P-21, O'Regan Winter 2022 



                    YORK-O'REGAN-W22SPG21                     


                                            1 Member                     


                                            1 Guide authored