Difficulty

Moderate

Steps

9

Time Required

                          1 - 3 hours

Sections

1

  • PVC Hub Combo Wye Fitting
  • 9 steps

Flags

0

  • BackPipe

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              PVC Hub Combo Wye Fitting
  • Using the shovel, dig out around base of pipe.

Using the shovel, dig out around base of pipe.

1024

Step 2

  • Using the hack saw, cut the broken pipe at the joint connections.

Using the hack saw, cut the broken pipe at the joint connections.

Step 3

  • Using the brush and towel, clean the pipe ends at least one inch on both ends.

Using the brush and towel, clean the pipe ends at least one inch on both ends.

Step 4

  • Fit all PVC pieces on to ensure that they all fit before you cement them together.

Fit all PVC pieces on to ensure that they all fit before you cement them together.

Step 5

  • With the measuring tape, measure and cut the straight PVC pipe to fit between the existing pipe and Charlotte pipe PVC hub combo wye fitting.

With the measuring tape, measure and cut the straight PVC pipe to fit between the existing pipe and Charlotte pipe PVC hub combo wye fitting.

Step 6

  • Apply the primer on the outside end of the straight pipe and inside the end of the Charlotte pipe PVC hub combo wye fitting.

Apply the primer on the outside end of the straight pipe and inside the end of the Charlotte pipe PVC hub combo wye fitting.

Step 7

  • Apply the PVC cement on the ends of both the straight pipe and Charlotte pipe PVC hub combo wye fitting and press firmly together.

Apply the PVC cement on the ends of both the straight pipe and Charlotte pipe PVC hub combo wye fitting and press firmly together.

Step 8

  • Prime and glue the rest of the pieces together one at a time.

Prime and glue the rest of the pieces together one at a time.

Step 9

  • Twist rubber coupling sleeve over both the existing pipe and the short straight pipe. Secure the circle clamp by tightening the screws with the flat head screwdriver.

Twist rubber coupling sleeve over both the existing pipe and the short straight pipe. Secure the circle clamp by tightening the screws with the flat head screwdriver.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Michael Frizzell

Member since: 03/25/2020

169 Reputation

                                      1 Guide authored                  



                       Badges:
                       2

Team

                       University of Memphis, Team S5-G7, Willis Spring 2020                        

                                                  Member of University of Memphis, Team S5-G7, Willis Spring 2020 



                    UM-WILLIS-S20S5G7                     


                                            1 Member                     


                                            1 Guide authored