Difficulty

Moderate

Steps

9

Time Required

                          15 - 30 minutes

Sections

2

  • Automatic Document Feeder
  • 2 steps
  • Control Panel
  • 7 steps

Flags

0

  • BackBrother IntelliFax-2840

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Automatic Document Feeder
  • Remove the two 15 mm Phillips #1 screws securing the ADF at the rear of the fax machine.

Remove the two 15 mm Phillips #1 screws securing the ADF at the rear of the fax machine.

1024

Step 2

  • Gently pull the ADF up and away from the machine.

Gently pull the ADF up and away from the machine.

Step 3

              Control Panel
  • Gently lift up the control panel.

Gently lift up the control panel.

Step 4

  • Use a finger or prying tool to gently pop off the right side control arm (furthest from the handset).
  • Repeat for the left side control arm.
  • You can make this task easier by taking the handset out of the cradle and setting it aside.

Use a finger or prying tool to gently pop off the right side control arm (furthest from the handset).

Repeat for the left side control arm.

You can make this task easier by taking the handset out of the cradle and setting it aside.

Step 5

  • Do not attempt to completely remove the control panel yet, as it is still connected by a cable.
  • Lifting from the front edge, gently flip up the control panel.

Do not attempt to completely remove the control panel yet, as it is still connected by a cable.

Lifting from the front edge, gently flip up the control panel.

Step 6

  • While supporting the control panel with one hand, remove the three 12.2 mm Phillips #1 screws securing the rear control panel cover.

While supporting the control panel with one hand, remove the three 12.2 mm Phillips #1 screws securing the rear control panel cover.

Step 7

  • While still supporting the control panel, use your fingers or a spudger to gently free the two plastic clips securing the rear control panel cover.
  • Slide the rear control panel cover down slightly to free it from the three clips along the upper edge.

While still supporting the control panel, use your fingers or a spudger to gently free the two plastic clips securing the rear control panel cover.

Slide the rear control panel cover down slightly to free it from the three clips along the upper edge.

Step 8

  • Separate the rear control panel cover from the control panel.

Separate the rear control panel cover from the control panel.

Step 9

  • Gently pull the control panel cable straight out from its connector.
  • The control panel should now come free.

Gently pull the control panel cable straight out from its connector.

The control panel should now come free.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 1 other contributor 


                    Geoff Wacker

Member since: 09/30/2013

87,540 Reputation

                                      89 Guides authored                  



                       Badges:
                       44







                                                        +41 more badges