Brother Pt 110 Keypad Contacts Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

Suggest a time??

Sections

Batteries
2 steps
Back Plate
6 steps
Keypad Contacts
3 steps

Flags

BackBrother PT-110
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Batteries

Push on the side of the cover, and remove it.

Push on the side of the cover, and remove it.

1024

Step 2

Remove the batteries.

Remove the batteries.

Step 3

              Back Plate

Unscrew the two 9 mm Phillips #1 screws from the top and bottom.
Total: 2 x Screws

Unscrew the two 9 mm Phillips #1 screws from the top and bottom.

Total: 2 x Screws

Step 4

First: To separate the top cover from the body, insert a spudger between the two halves.
Gently twist the spudger until the two halves separate. Do this in multiple spots around the perimeter of the cover to distribute the pressure.
DO NOT PULL HALVES APART. There are wired connections inside that must be disconnected before halves can be fully separated.

First: To separate the top cover from the body, insert a spudger between the two halves.

Gently twist the spudger until the two halves separate. Do this in multiple spots around the perimeter of the cover to distribute the pressure.

DO NOT PULL HALVES APART. There are wired connections inside that must be disconnected before halves can be fully separated.

Step 5

Gently separate the two covers, ensuring wires are not taut.

Gently separate the two covers, ensuring wires are not taut.

Step 6

Gently grasp the ribbon wire and top cover, then gently pull the ribbon wire out of its connection.

Gently grasp the ribbon wire and top cover, then gently pull the ribbon wire out of its connection.

Step 7

Carefully pinch the top of the connector.
Pull perpendicular to the device until the wire is disconnected.
It may require more force than expected to disconnect the wires.

Carefully pinch the top of the connector.

Pull perpendicular to the device until the wire is disconnected.

It may require more force than expected to disconnect the wires.

Step 8

Unscrew the three 9 mm Phillips #1 screws shown.
Total: 3 x Screws

Unscrew the three 9 mm Phillips #1 screws shown.

Total: 3 x Screws

Step 9

              Keypad Contacts

Unscrew both 6 mm Phillips #1 screws from the circuit board.
Total screws: 2

Unscrew both 6 mm Phillips #1 screws from the circuit board.

Total screws: 2

Step 10

Gently lift the circuit board out.

Gently lift the circuit board out.

Step 11

Peel the keypad contacts up from the plastic casing.

Peel the keypad contacts up from the plastic casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Kimberly Larsen

Member since: 09/28/2016

183 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       IUPUI, Team 1-1, Harley Fall 2016                        

                                                  Member of IUPUI, Team 1-1, Harley Fall 2016 



                    IUPUI-HARLEY-F16S1G1                     


                                            3 Members                     


                                            7 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team