Brother Pt 1290 Tape Cassette Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 - 20 minutes

Sections

Tape Cassette
5 steps

Flags

BackBrother PT-1290
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

Before beginning, remove the AC adapter from the label maker and make sure the device is powered off.

Step 1

              Removing the back piece of the label maker.

There is a plastic tab located on the back of the label maker near the top. The tab has ridges on it to help you identify where to press. Push on this tab to release the back of the label maker.
Gently pull the label maker apart - it will split in half.
Be careful! The electronics inside are very sensitive and easily damaged.

There is a plastic tab located on the back of the label maker near the top. The tab has ridges on it to help you identify where to press. Push on this tab to release the back of the label maker.

Gently pull the label maker apart - it will split in half.

Be careful! The electronics inside are very sensitive and easily damaged.

1024

Step 2

              Removing batteries or AC adapter.

Remove the AAA batteries before you proceed on to replacing the tape cassette.

Remove the AAA batteries before you proceed on to replacing the tape cassette.

Step 3

              Replacing tape cassette.

Align and insert a new tape cassette. Make sure the center of the cassette snaps into place. The tape must feed between the tape guides.
If the ribbon has become too loose, use your finger to turn the white wheel in the direction of the arrow on the tape cassette. This will wind up any excess tape.
Only use Brother TZ tapes with this machine.

Align and insert a new tape cassette. Make sure the center of the cassette snaps into place. The tape must feed between the tape guides.

If the ribbon has become too loose, use your finger to turn the white wheel in the direction of the arrow on the tape cassette. This will wind up any excess tape.

Only use Brother TZ tapes with this machine.

Step 4

              Evaluating

Place the batteries back inside, then close the cover.
Check that all six batteries are inserted correctly.

Place the batteries back inside, then close the cover.

Check that all six batteries are inserted correctly.

Step 5

              Feeding Tape.

To test the new cassette, make a new label. Press “Shift” and “Print” to feed the tape, then use the cutting lever on the upper-right corner of the machine.

To test the new cassette, make a new label. Press “Shift” and “Print” to feed the tape, then use the cutting lever on the upper-right corner of the machine.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 7 other contributors

                    Lorraine Canez

Member since: 10/25/2014

318 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Gateway, Team 1-4, Johnson Fall 2014                        

                                                  Member of Gateway, Team 1-4, Johnson Fall 2014 



                    GCC-JOHNSON-F14S1G4                     


                                            3 Members                     


                                            6 Guides authored

Uwe Seiler - Nov 20, 2021

Wie wird die Kassette eingesetzt

Introduction#

Team#

Introduction

Team