Difficulty

Moderate

Steps

7

Time Required

                          10 - 15 minutes

Sections

4

  • Battery
  • 2 steps
  • Back of Device
  • 2 steps
  • Face Plate
  • 2 steps
  • Keyboard
  • 1 step

Flags

3

Inconsistent Images

Updating the images on this guide to be more consistent with the prerequisites would increase its awesomeness.

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackBrother PT-D200

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.

Flip the device over and press down on the indication arrows located at the top center of the back cover and pull it open.

1024

Step 2

  • Remove the six AAA batteries.

Remove the six AAA batteries.

Step 3

              Back of Device
  • Use the Helping Hand 1/4" screwdriver to unscrew the six 3/16" corner screws.

Use the Helping Hand 1/4" screwdriver to unscrew the six 3/16" corner screws.

Step 4

  • Close the back cover and then flip the device over and separate the top half from the bottom half as shown.
  • Be gentle when lifting the top of the device, there is a ribbon cable attaching the two halves together.

Close the back cover and then flip the device over and separate the top half from the bottom half as shown.

Be gentle when lifting the top of the device, there is a ribbon cable attaching the two halves together.

Step 5

              Face Plate
  • On the top portion of the device there are four grey clips locking the faceplate in place. The two top clips are circled in the image. The two others are located in the other corners of the device.

On the top portion of the device there are four grey clips locking the faceplate in place. The two top clips are circled in the image. The two others are located in the other corners of the device.

Step 6

  • Pull the clips inward two at a time, first the top then the bottom, to snap the face plate off.

Pull the clips inward two at a time, first the top then the bottom, to snap the face plate off.

Step 7

              Keyboard
  • Peel off the rubber keyboard of the device.

Peel off the rubber keyboard of the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    [deleted]

Member since: 01/24/2014

301 Reputation

                                      3 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges