Difficulty
Easy
Steps
5
Time Required
5 minutes
Sections
1
- Back Panel
- 5 steps
Flags
0
BackBrother Xl 2600
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Place the machine on a solid surface.
- Remove the 14mm Phillips #2 screw holding on the face cover.
Place the machine on a solid surface.
Remove the 14mm Phillips #2 screw holding on the face cover.
1024
Step 2
- Remove the two 14mm Phillips #2 screws and two 22mm Phillips #2 screws that secure the rear casing.
Remove the two 14mm Phillips #2 screws and two 22mm Phillips #2 screws that secure the rear casing.
Step 3
- Lay the machine on its side.
- Remove the four 10mm Phillips #2 screws that hold the bottom panel in place.
- The feet will come off with the screws.
Lay the machine on its side.
Remove the four 10mm Phillips #2 screws that hold the bottom panel in place.
The feet will come off with the screws.
Step 4
- Remove the bottom panel.
Remove the bottom panel.
Step 5
- Place the machine upright.
- Remove the rear casing.
- You may have to wiggle the panel and pull at the same time.
Place the machine upright.
Remove the rear casing.
You may have to wiggle the panel and pull at the same time.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
5 other people completed this guide.
Author
with 3 other contributors
Allison
Member since: 02/03/2014
302 Reputation
2 Guides authored
Badges:
8
+5 more badges
Team
Cal Poly, Team 2-12, Amido Winter 2014
Member of Cal Poly, Team 2-12, Amido Winter 2014
CPSU-AMIDO-W14S2G12
4 Members
12 Guides authored
