Difficulty
Moderate
Steps
6
Time Required
Suggest a time??
Sections
1
- Head and Handle
- 6 steps
Flags
0
BackBush Pump
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Step 1
Head and Handle
- Test pump performance by pumping 40 strokes.
- An effective pump should return at least 10 liters.
Test pump performance by pumping 40 strokes.
An effective pump should return at least 10 liters.
1024
Step 2
- Remove the two pins connecting the handle to the slider.
Remove the two pins connecting the handle to the slider.
Step 3
- Pull the two lever arms away from the slider.
Pull the two lever arms away from the slider.
Step 4
- Lift the two pins attaching the pump frame to the head and handle up, off of the pump frame.
Lift the two pins attaching the pump frame to the head and handle up, off of the pump frame.
Step 5
- Throughout this step, make sure you support the handle and head with at least three hands.
- Slide the bearing rod out of the head.
- Inspect the bearing rod and head for any wear or tear.
Throughout this step, make sure you support the handle and head with at least three hands.
Slide the bearing rod out of the head.
Inspect the bearing rod and head for any wear or tear.
Step 6
- Remove the head and handle, and place them on a clean surface to prevent contamination.
Remove the head and handle, and place them on a clean surface to prevent contamination.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 4 other contributors
Jake Devincenzi
Member since: 04/18/2011
116,089 Reputation
57 Guides authored
Badges:
51
+48 more badges
