Difficulty

Easy

Steps

5

Time Required

                          20 - 30 minutes

Sections

2

  • Shroud
  • 4 steps
  • Pressure Gauge
  • 1 step

Flags

1

This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.

  • BackCampbell Hausfeld FP204800

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Remove Shroud Screws
  • Unscrew the four 1cm long shroud screws using a 6mm Allen Wrench.

Unscrew the four 1cm long shroud screws using a 6mm Allen Wrench.

1024

Step 2

              Remove Shroud
  • Remove the plastic shroud from the compressor.
  • Do not pull the shroud too far from the compressor. You could damage the on/off switch wiring.

Remove the plastic shroud from the compressor.

Do not pull the shroud too far from the compressor. You could damage the on/off switch wiring.

Step 3

              Remove The Wiring From the Pressure Switch to the On/Off Switch
  • Gently pull the wire attached from the pressure switch to the on/off switch.
  • It should come off the pressure switch with ease.
  • Make sure you are pulling the correct wire. The pressure switch could be in a different configuration on your compressor than in the picture.

Gently pull the wire attached from the pressure switch to the on/off switch.

It should come off the pressure switch with ease.

Make sure you are pulling the correct wire. The pressure switch could be in a different configuration on your compressor than in the picture.

Step 4

              Remove the On/Off Switch Wiring
  • Gently pull the wire connected from the on/off switch to the motor of the compressor.
  • It should be the only wire keeping the shroud from being lifted from the compressor.

Gently pull the wire connected from the on/off switch to the motor of the compressor.

It should be the only wire keeping the shroud from being lifted from the compressor.

Step 5

              Remove the pressure gauges
  • Using a Smart Wrench, remove the old/broken pressure gauge or gauges.

Using a Smart Wrench, remove the old/broken pressure gauge or gauges.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 2 other contributors 


                    Eric

Member since: 10/09/2014

409 Reputation

                                      3 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Cal Poly, Team 14-29, Maness Fall 2014                        

                                                  Member of Cal Poly, Team 14-29, Maness Fall 2014 



                    CPSU-MANESS-F14S14G29                     


                                            4 Members                     


                                            7 Guides authored