Difficulty

Easy

Steps

6

Time Required

                          5 - 7 minutes

Sections

2

  • Exterior Shell
  • 2 steps
  • Fan
  • 4 steps

Flags

0

  • BackCanon LV-7210

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Exterior Shell
  • Remove the 4 exterior 9mm Phillips #0 screws. They are located on the sides of the projector.

Remove the 4 exterior 9mm Phillips #0 screws. They are located on the sides of the projector.

1024

Step 2

  • Gently lift up on the shell with both hands, from the back to the front.
  • The shell will still be attached by a small cord in the front, so be careful not to tear it loose.

Gently lift up on the shell with both hands, from the back to the front.

The shell will still be attached by a small cord in the front, so be careful not to tear it loose.

Step 3

              Fan
  • Remove the two 7mm Phillips #0 screws that attach the fan to the motherboard of the projector.

Remove the two 7mm Phillips #0 screws that attach the fan to the motherboard of the projector.

Step 4

  • Remove the fan by pulling up gently from the top.
  • Be careful to not pull too hard or quickly, since the fan is still attached to the projector with some other wires.

Remove the fan by pulling up gently from the top.

Be careful to not pull too hard or quickly, since the fan is still attached to the projector with some other wires.

Step 5

  • Remove the 7mm Phillips #0 screw that fastens the black ground wire connected to the fan and the projector.

Remove the 7mm Phillips #0 screw that fastens the black ground wire connected to the fan and the projector.

Step 6

  • Peel the sticker up on the back of the fan to expose the port where the red, white, and black wires are attached.
  • The wires will need to be cut with small wire cutters in order to completely remove the fan.

Peel the sticker up on the back of the fan to expose the port where the red, white, and black wires are attached.

The wires will need to be cut with small wire cutters in order to completely remove the fan.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    William Christian

Member since: 10/05/2016

331 Reputation

                                      3 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       USF Tampa, Team 9-3, Lacy Fall 2016                        

                                                  Member of USF Tampa, Team 9-3, Lacy Fall 2016 



                    USFT-LACY-F16S9G3                     


                                            4 Members                     


                                            3 Guides authored