Difficulty
Easy
Steps
2
Time Required
5 minutes
Sections
1
- Light Filter Foam
- 2 steps
Flags
Incorrect Tools
Help make this guide better by using the correct tools in images and/or text.
BackCanon AE-1
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Light Filter Foam
- Open the film compartment by pulling on the release pin.
- Use a 3mm slot screw driver to scrape old light filter foam cleanly off.
- Then use Isopropyl Alcohol to assist in removing the old light filter foam.
Open the film compartment by pulling on the release pin.
Use a 3mm slot screw driver to scrape old light filter foam cleanly off.
Then use Isopropyl Alcohol to assist in removing the old light filter foam.
1024
Step 2
- Placing light filter foam improperly could result in light exposure on film.
- Cut the new light filter foam to size so it can fit in the slot.
- Place the sticky side of the new strip of light filter foam over old foams location.
Placing light filter foam improperly could result in light exposure on film.
Cut the new light filter foam to size so it can fit in the slot.
Place the sticky side of the new strip of light filter foam over old foams location.
To reassemble your device, follow these instructions.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 6 other contributors
Brad
Member since: 10/04/2011
47 Reputation
1 Guide authored
Badges:
6
+3 more badges
Team
UW Stout, Team 5-1, Zhou Fall 2011
Member of UW Stout, Team 5-1, Zhou Fall 2011
UWSTOUT-ZHOU-F11S5G1
3 Members
8 Guides authored
