Canon Canoscan N670U Disassembly Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          5 - 15 minutes            

Sections

1

• Canon CanoScan N670U Disassembly
• 8 steps

Flags

0

• BackCanon CanoScan N670U

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

To reach the inner components of the scanner, you must:

• Remove the two side bars that hold the glass scanner bed in place.Remove the glass scanner bed itself.

What you need

Step 1

              Canon CanoScan N670U Disassembly               

• Open up your Canon CanoScan N670U to an upright position.

Open up your Canon CanoScan N670U to an upright position.

1024

Step 2

• Turn your device so that you’re facing the long side of the Canon CanoScan N670U.
• Locate the small crevice between the plastic components of the scanner bed and the scanner base.

Turn your device so that you’re facing the long side of the Canon CanoScan N670U.

Locate the small crevice between the plastic components of the scanner bed and the scanner base.

Step 3

• Carefully insert a metal spudger tool in the crevice and slowly cut through the adhesive between the plastic components.
• You may cut small bits of the plastic as you’re slicing the adhesive. Do not forcefully bend the plastic strip as you’re cutting or it will snap.

Carefully insert a metal spudger tool in the crevice and slowly cut through the adhesive between the plastic components.

You may cut small bits of the plastic as you’re slicing the adhesive. Do not forcefully bend the plastic strip as you’re cutting or it will snap.

Step 4

• Once the adhesive strip is sliced through, the plastic bar that is attached should release. Set aside the plastic bar.

Once the adhesive strip is sliced through, the plastic bar that is attached should release. Set aside the plastic bar.

Step 5

• Repeat steps 2-4 for the other side of the scanner.

Repeat steps 2-4 for the other side of the scanner.

Step 6

• Use your hands or a metal spudger tool to push the plastic bar at the bottom of the glass scanner bed forward until you can’t push it any farther.

Use your hands or a metal spudger tool to push the plastic bar at the bottom of the glass scanner bed forward until you can’t push it any farther.

Step 7

• Insert the metal spudger tool underneath the glass scanner bed. The front of the scanner bed should be resting on top of the tool.

Insert the metal spudger tool underneath the glass scanner bed. The front of the scanner bed should be resting on top of the tool.

Step 8

• Slowly pull the glass scanner bed towards you and set the piece aside.

Slowly pull the glass scanner bed towards you and set the piece aside.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Stephen Bui                     

Member since: 09/19/2015

558 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       USF Sarasota-Manatee, Team 1-1, Stewart Fall 2015                        

                                                  Member of USF Sarasota-Manatee, Team 1-1, Stewart Fall 2015 



                    USFSM-STEWART-F15S1G1                     


                                            5 Members                     


                                            16 Guides authored