Difficulty

Easy

Steps

10

Time Required

                          10 minutes

Sections

4

  • Batteries
  • 2 steps
  • Side Panel with Lever
  • 3 steps
  • Front Panel
  • 3 steps
  • Bottom Panel
  • 2 steps

Flags

0

  • BackCanon EOS 300

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Batteries
  • Open up the battery door.

Open up the battery door.

1024

Step 2

  • Remove the batteries from the camera by sliding them out into your palm.

Remove the batteries from the camera by sliding them out into your palm.

Step 3

              Side Panel with Lever
  • Release the side latch to open the back panel.

Release the side latch to open the back panel.

Step 4

  • Remove the two black 4.5mm screws above and below the latch.

Remove the two black 4.5mm screws above and below the latch.

Step 5

  • Using your finger, carefully pry open the side panel from the top of camera.
  • Pull panel downwards to remove.
  • Make sure to keep track of the small black piece of rubber under the latch.

Using your finger, carefully pry open the side panel from the top of camera.

Pull panel downwards to remove.

Make sure to keep track of the small black piece of rubber under the latch.

Step 6

              Front Panel
  • Remove the two silver 6mm Phillips #1 screws.

Remove the two silver 6mm Phillips #1 screws.

Step 7

  • Flip camera over to the bottom.
  • Remove the one 5mm Phillips #1 silver screw.

Flip camera over to the bottom.

Remove the one 5mm Phillips #1 silver screw.

Step 8

  • Remove the front panel by pulling away from the side with the lever.

Remove the front panel by pulling away from the side with the lever.

Step 9

              Bottom Panel
  • Remove three black 7.3mm Phillips #1 screws located on the corners of the camera.
  • Remove five black 4.8mm Phillips #1 screws.

Remove three black 7.3mm Phillips #1 screws located on the corners of the camera.

Remove five black 4.8mm Phillips #1 screws.

Step 10

  • Simply remove the bottom panel by prying it off with your finger.
  • When removing the panel, be sure the bottom of the camera is facing upright. There are loose gears that may fall out.
  • Be wary of a loose piece of foam attached to the bottom panel.

Simply remove the bottom panel by prying it off with your finger.

When removing the panel, be sure the bottom of the camera is facing upright. There are loose gears that may fall out.

Be wary of a loose piece of foam attached to the bottom panel.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 3 other contributors 


                    Tammy Kong

Member since: 01/23/2014

744 Reputation

                                      6 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       Cal Poly, Team 6-20, Maness Winter 2014                        

                                                  Member of Cal Poly, Team 6-20, Maness Winter 2014 



                    CPSU-MANESS-W14S6G20                     


                                            4 Members                     


                                            21 Guides authored

Ricardo Alonso Gurrea - Jan 9, 2023

Reply

muy buena la explicacion de como desmontar la maquina. Te has gadano los 30 puntos