Canon Eos 60D Rear Lcd Screen Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

2

• Rear LCD Screen Dissasembly
• 4 steps
• Rear LCD Screen
• 2 steps

Flags

0

• BackCanon EOS 60D

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Be sure to use a magnetic mat or small container for your screws, as they are very small and easy to misplace.

What you need

Step 1

              Rear LCD Screen Dissasembly               

• Take the LCD out of its place to expose the Phillips #PH00 screws.
• Remove the two 2.5 mm Phillips #PH00 black screws on both sides of the LCD screen.
• Next remove the two 3 mm Phillips #PH00 black screws near both sides of the base where the screen swivels.

Take the LCD out of its place to expose the Phillips #PH00 screws.

Remove the two 2.5 mm Phillips #PH00 black screws on both sides of the LCD screen.

Next remove the two 3 mm Phillips #PH00 black screws near both sides of the base where the screen swivels.

1024

Step 2

• Using a plastic opening tool, carefully pry off the back cover of the LCD.

Using a plastic opening tool, carefully pry off the back cover of the LCD.

Step 3

• Remove the 3 mm Phillips #PH00 silver screw on the side of the screen.
• Turn the screen to remove the second 3 mm Phillips #PH00 silver screw.

Remove the 3 mm Phillips #PH00 silver screw on the side of the screen.

Turn the screen to remove the second 3 mm Phillips #PH00 silver screw.

Step 4

• Using the tweezers, carefully disconnect the rear connector by pulling it away from the screen.

Using the tweezers, carefully disconnect the rear connector by pulling it away from the screen.

Step 5

              Rear LCD Screen               

• Remove the two 2.5 mm Phillips #PH00 silver screws using the PH00 screwdriver.
• Using the plastic Spudger opening tool, carefully lift up on the medal tabs next to where the screws were located.

Remove the two 2.5 mm Phillips #PH00 silver screws using the PH00 screwdriver.

Using the plastic Spudger opening tool, carefully lift up on the medal tabs next to where the screws were located.

Step 6

• Finally, remove the LCD screen by grabbing the clear plastic tab and lifting it carefully.

Finally, remove the LCD screen by grabbing the clear plastic tab and lifting it carefully.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Author

                                      with 2 other contributors 

                    Alejandro Cabrera                     

Member since: 08/25/2015

413 Reputation

                                      2 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges                           

Team

                       USF Tampa, Team 16-6, Wollert Fall 2015                        

                                                  Member of USF Tampa, Team 16-6, Wollert Fall 2015 



                    USFT-WOLLERT-F15S16G6                     


                                            3 Members                     


                                            14 Guides authored