Canon Eos 70D Efs 18 135Mm Lens Main Board Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          15 - 25 minutes

Sections

EFS 18-135mm Lens Main Board
5 steps

Flags

BackCanon EOS 70D
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              EFS 18-135mm Lens Main Board

First, detach the lens by pressing and holding the release button highlighted in the picture.
Next, grab the lens and rotate it counter-clockwise when looking at the camera.
Finally, when the camera stops rotating, pull the lens away from the camera.

First, detach the lens by pressing and holding the release button highlighted in the picture.

Next, grab the lens and rotate it counter-clockwise when looking at the camera.

Finally, when the camera stops rotating, pull the lens away from the camera.

1024

Step 2

Remove the four 5.5-mm Phillips #000 screws for the lens mount ring (silver ring).
Remove the two 4-mm Phillips #000 screws mounting the main board connector.
This guide involves removing a lot of very small screws so be sure to have a magnet board to keep track of them.

Remove the four 5.5-mm Phillips #000 screws for the lens mount ring (silver ring).

Remove the two 4-mm Phillips #000 screws mounting the main board connector.

This guide involves removing a lot of very small screws so be sure to have a magnet board to keep track of them.

Step 3

Using a spudger, pull the connector loose from the barrel switch ring assembly.
Set barrel switch ring assembly to the side.

Using a spudger, pull the connector loose from the barrel switch ring assembly.

Set barrel switch ring assembly to the side.

Step 4

Using a spudger, pull the five connectors out of their housing.
Use very gentle pressure when pulling connectors out of the lens main board, as they tend to break easily.

Using a spudger, pull the five connectors out of their housing.

Use very gentle pressure when pulling connectors out of the lens main board, as they tend to break easily.

Step 5

Remove the two 4-mm Phillips #000 main board mounting screws.
Remove the main board from the lens with your hand.
The main board is now successfully removed from the lens.

Remove the two 4-mm Phillips #000 main board mounting screws.

Remove the main board from the lens with your hand.

The main board is now successfully removed from the lens.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    Paul

Member since: 03/12/2018

762 Reputation

                                      3 Guides authored                  



                       Badges:
                       11







                                                        +8 more badges

Team

                       University of Memphis, Team S2-G5, Kim Spring 2018                        

                                                  Member of University of Memphis, Team S2-G5, Kim Spring 2018 



                    UM-KIM-S18S2G5                     


                                            3 Members                     


                                            11 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team