Difficulty

Difficult

Steps

8

Time Required

                          15 - 20 minutes

Sections

3

  • Front Panel
  • 3 steps
  • Top Panel
  • 4 steps
  • Viewfinder
  • 1 step

Flags

0

  • BackCanon EOS Rebel G

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Front Panel
  • Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

Using a #00 Phillips screw driver, remove three 4.4 mm Phillips screws as indicated by the red circles.

1024

Step 2

  • Using your finger, peel back the textured grip so the components are separated.

Using your finger, peel back the textured grip so the components are separated.

Step 3

  • Using the flat end of a spudger, loosen the connection between the front panel and the device.
  • Remove the front panel using your hands.

Using the flat end of a spudger, loosen the connection between the front panel and the device.

Remove the front panel using your hands.

Step 4

              Top Panel
  • Turn Camera over.
  • Using a #00 Phillips screw driver, unscrew the two 4.9 mm Phillips screws located on either side of the viewfinder.

Turn Camera over.

Using a #00 Phillips screw driver, unscrew the two 4.9 mm Phillips screws located on either side of the viewfinder.

Step 5

  • Using a #00 Phillips screw driver, unscrew the one 5.7 mm Phillips screw located next to the LCD screen.

Using a #00 Phillips screw driver, unscrew the one 5.7 mm Phillips screw located next to the LCD screen.

Step 6

  • Lay the camera on its back.
  • Unsolder the flash connection from the motherboard as noted by the blue circle.

Lay the camera on its back.

Unsolder the flash connection from the motherboard as noted by the blue circle.

Step 7

  • Remove the top panel by lifting it from the back, pushing it forward over the camera and letting it rotate down in front of the camera.

Remove the top panel by lifting it from the back, pushing it forward over the camera and letting it rotate down in front of the camera.

Step 8

              Viewfinder
  • Unscrew the screws on either side of the viewfinder until the viewfinder can be lifted off
  • Two 8.5 mm Phillips screws

Unscrew the screws on either side of the viewfinder until the viewfinder can be lifted off

Two 8.5 mm Phillips screws

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 


                    Kyle Reis

Member since: 04/02/2012

52 Reputation

                                      4 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges

Team

                       Cal Poly, Team 14-9, Forte Spring 2012                        

                                                  Member of Cal Poly, Team 14-9, Forte Spring 2012 



                    CPSU-FORTE-S12S14G9                     


                                            5 Members                     


                                            24 Guides authored