Difficulty

Moderate

Steps

13

Time Required

                          20 minutes

Sections

2

  • Back Panel
  • 8 steps
  • Front Panel
  • 5 steps

Flags

0

  • BackCanon EOS Rebel XSi / 450D

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Back Panel
  • Squeeze the eyepiece between your index finger and thumb and lift up and off.

Squeeze the eyepiece between your index finger and thumb and lift up and off.

1024

Step 2

  • Using the PH000 screwdriver head, remove the four 4 mm screws on the bottom of the camera.

Using the PH000 screwdriver head, remove the four 4 mm screws on the bottom of the camera.

Step 3

  • Using the PH000 screwdriver head, remove the two 3mm screws on the right side of the camera (from the LCD screen).

Using the PH000 screwdriver head, remove the two 3mm screws on the right side of the camera (from the LCD screen).

Step 4

  • Remove grip by slowly peeling off.

Remove grip by slowly peeling off.

Step 5

  • Using the PH000 screwdriver, remove the four 4mm screws behind the eyepiece.

Using the PH000 screwdriver, remove the four 4mm screws behind the eyepiece.

Step 6

  • Using the PH000 screwdriver head, remove one 4 mm screw on the left side of the camera (from the LCD screen).

Using the PH000 screwdriver head, remove one 4 mm screw on the left side of the camera (from the LCD screen).

Step 7

  • Remove the side panel by lifting off with fingers.

Remove the side panel by lifting off with fingers.

Step 8

  • Use hands to pry off the back panel.

Use hands to pry off the back panel.

Step 9

              Front Panel
  • Using the PH000 screwdriver head, remove the four 3mm screws on the front

Using the PH000 screwdriver head, remove the four 3mm screws on the front

Step 10

  • Remove front grip by gently peeling from the edge towards the center of the camera

Remove front grip by gently peeling from the edge towards the center of the camera

Step 11

  • Using the PH000 screwdriver head, unscrew the 3 mm screw that was under the grip

Using the PH000 screwdriver head, unscrew the 3 mm screw that was under the grip

Step 12

  • Using the PH000 screwdriver, remove the 4mm screw at the bottom of the camera

Using the PH000 screwdriver, remove the 4mm screw at the bottom of the camera

Step 13

  • Remove the front panel by using tweezers to pry the panel over the metal ring protrusion

Remove the front panel by using tweezers to pry the panel over the metal ring protrusion

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 4 other contributors 


                    Erik Mork

Member since: 01/27/2017

596 Reputation

                                      5 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       Cal Poly, Team 22-10, Maness Winter 2017                        

                                                  Member of Cal Poly, Team 22-10, Maness Winter 2017 



                    CPSU-MANESS-W17S22G10                     


                                            4 Members                     


                                            10 Guides authored