Canon Fs30 Lcd Screen Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          5 minutes            

Sections

1

• LCD Screen
• 6 steps

Flags

0

• BackCanon FS30

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              LCD Screen               

• Locate battery compartment cover. Turn the device over and locate the battery compartment cover.
• Place a finger or thumb on the textured section of the battery compartment cover and push forward until you hear a click. Then lift the battery compartment cover.

Locate battery compartment cover. Turn the device over and locate the battery compartment cover.

Place a finger or thumb on the textured section of the battery compartment cover and push forward until you hear a click. Then lift the battery compartment cover.

1024

Step 2

• Locate the grey latch and move it aside. The battery is spring loaded and will pop up.
• Remove the battery.

Locate the grey latch and move it aside. The battery is spring loaded and will pop up.

Remove the battery.

Step 3

• Using the Phillips #000, remove the two screws on the LCD panel.
• Using the Phillips #000, remove two more screws near the LCD panel swivel point.

Using the Phillips #000, remove the two screws on the LCD panel.

Using the Phillips #000, remove two more screws near the LCD panel swivel point.

Step 4

• Use the plastic opening tool to remove the plastic cover from the LCD panel.

Use the plastic opening tool to remove the plastic cover from the LCD panel.

Step 5

• Locate and remove two screws on the logic board.
• Use the plastic opening tool to open the ZIF (zero insertion force) connector. The LCD ribbon should pop up.

Locate and remove two screws on the logic board.

Use the plastic opening tool to open the ZIF (zero insertion force) connector. The LCD ribbon should pop up.

Step 6

• Locate the LCD screen underneath the logic board and slide it out.

Locate the LCD screen underneath the logic board and slide it out.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Emanuel Keller                     

Member since: 02/28/2017

419 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       USF Tampa, Team S1-G4, Nance Spring 2017                        

                                                  Member of USF Tampa, Team S1-G4, Nance Spring 2017 



                    USFT-NANCE-S17S1G4                     


                                            4 Members                     


                                            10 Guides authored