Difficulty
Very easy
Steps
4
Time Required
5 minutes
Sections
2
- Front Paneling
- 3 steps
- Right Side Paneling
- 1 step
Flags
0
BackCanon ImageCLASS MF4350d
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Front Paneling
- Lift the printer lid up as shown in the photo.
Lift the printer lid up as shown in the photo.
1024
Step 2
- Locate and remove the two 10mm side screws. There is one on each side.
Locate and remove the two 10mm side screws. There is one on each side.
Step 3
- Unhook the plastic panel from the printer starting from the top.
- You may need to wiggle the panel a bit to loosen it.
- To remove the bottom part of the paneling gently lay the printer on its back.
- The scanner lid needs to be supported when moving the printer
Unhook the plastic panel from the printer starting from the top.
You may need to wiggle the panel a bit to loosen it.
To remove the bottom part of the paneling gently lay the printer on its back.
The scanner lid needs to be supported when moving the printer
Step 4
Right Side Paneling
- Gently unhook the right side paneling (as looking at the printer’s front face) from the printer.
- Use a gentle back and forth motion to wiggle the hooks out.
Gently unhook the right side paneling (as looking at the printer’s front face) from the printer.
Use a gentle back and forth motion to wiggle the hooks out.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 4 other contributors
Helena Yanez
Member since: 09/29/2013
446 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team 13-1, Forte Fall 2013
Member of Cal Poly, Team 13-1, Forte Fall 2013
CPSU-FORTE-F13S13G1
5 Members
8 Guides authored
