Difficulty
Difficult
Steps
11
Time Required
30 - 45 minutes
Sections
1
- Ink Head
- 11 steps
Flags
0
BackCanon PIXMA MP620B
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Ink Head
- There are a few tabs on the top of the panel that hook down and into the black side panel. Insert the tool in-between the black panel and the blue panel as shown and pull the two pieces apart.
- You will hear some snapping. Don’t panic: this is just the hooks un-clipping.
There are a few tabs on the top of the panel that hook down and into the black side panel. Insert the tool in-between the black panel and the blue panel as shown and pull the two pieces apart.
You will hear some snapping. Don’t panic: this is just the hooks un-clipping.
1024
Step 2
- Repeat the same process on the left side panel.
Repeat the same process on the left side panel.
Step 3
- Unhook the lid support by sliding the hook down and to the left. Make sure the support is fully disconnected before proceeding.
Unhook the lid support by sliding the hook down and to the left. Make sure the support is fully disconnected before proceeding.
Step 4
- Remove the four black screws on the back panels from both the left and right side.
Remove the four black screws on the back panels from both the left and right side.
Step 5
- Remove the scanner by pulling the side panels out until the scanner pin is free. Set the scanner aside.
- The scanner will still be attached with wires on the right side. Be careful not to yank the part away from the main body of the printer.
Remove the scanner by pulling the side panels out until the scanner pin is free. Set the scanner aside.
The scanner will still be attached with wires on the right side. Be careful not to yank the part away from the main body of the printer.
Step 6
- Press down on the clip on the left side of the printer until it clicks, and pull the panel free.
Press down on the clip on the left side of the printer until it clicks, and pull the panel free.
Step 7
- Press down on the clip on the right side panel until it clicks and then pull the panel free.
Press down on the clip on the right side panel until it clicks and then pull the panel free.
Step 8
- Remove the plastic cover by depressing the clip located on the right side of the printer. Press the clip inwards until it clicks, and then lift the cover upwards and off the printer.
Remove the plastic cover by depressing the clip located on the right side of the printer. Press the clip inwards until it clicks, and then lift the cover upwards and off the printer.
Step 9
Remove the three screws holding the top rear slider rail
- Unscrew the three screws holding the rail.
Unscrew the three screws holding the rail.
Step 10
Remove the guiding cord
- Remove the cord by pulling upwards on it and unhooking it from the pulleys on either end.
Remove the cord by pulling upwards on it and unhooking it from the pulleys on either end.
Step 11
Remove the ink head
- Remove the ink head by pulling it away from the rail.
Remove the ink head by pulling it away from the rail.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 6 other contributors
Val Fedorikhin
Member since: 10/12/2014
860 Reputation
5 Guides authored
Badges:
15
+12 more badges
Team
Cal Poly, Team 6-21, Maness Fall 2014
Member of Cal Poly, Team 6-21, Maness Fall 2014
CPSU-MANESS-F14S6G21
4 Members
5 Guides authored
