Difficulty

Moderate

Steps

6

Time Required

                          15 - 30 minutes

Sections

1

  • USB Reader
  • 6 steps

Flags

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackCanon PIXMA MP620B

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

This replacement is moderate in difficulty. It can be tricky to get inside the side panels of the printer.

What you need

Step 1

              Pop off right blue side panel
  • Locate the tabs on the top of the panel that hook down and into the black side panel.
  • Insert the Spudger in-between the black panel and the blue panel as shown and pull the two pieces apart.
  • You will hear some snapping. Don’t panic: this is just the hooks un-clipping.

Locate the tabs on the top of the panel that hook down and into the black side panel.

Insert the Spudger in-between the black panel and the blue panel as shown and pull the two pieces apart.

You will hear some snapping. Don’t panic: this is just the hooks un-clipping.

1024

Step 2

              Loosen the back panel
  • Remove the two screws from the back right black panel using the Phillips #00 screwdriver.

Remove the two screws from the back right black panel using the Phillips #00 screwdriver.

Step 3

              Pull off black side panel
  • There is a tab you will have to push down to remove the part.
  • Once the tab is released, gently lift the cover away from the rest of the device to disengage the clips.
  • You will hear some snapping. Don’t panic: this is just the clips un-clipping.

There is a tab you will have to push down to remove the part.

Once the tab is released, gently lift the cover away from the rest of the device to disengage the clips.

You will hear some snapping. Don’t panic: this is just the clips un-clipping.

Step 4

              Take off the black side panel
  • After unclipping all the hooks, pull off the black side panel to reveal the inner circuit boards.

After unclipping all the hooks, pull off the black side panel to reveal the inner circuit boards.

Step 5

              Unscrew 2 screws from USB chip
  • Remove the two screws from the USB reader using the Phillips #00 screwdriver.
  • The angle for removing the screws can be somewhat challenging, try not to get too frustrated.

Remove the two screws from the USB reader using the Phillips #00 screwdriver.

The angle for removing the screws can be somewhat challenging, try not to get too frustrated.

Step 6

              Pull out USB chip and disconnect white wire
  • Disconnect the large white ribbon cable that leads to the USB reader. As you are pulling out the USB reader, carefully detach the ribbon.

Disconnect the large white ribbon cable that leads to the USB reader. As you are pulling out the USB reader, carefully detach the ribbon.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      4 other people completed this guide.

Author

                                      with 5 other contributors 


                    Val Fedorikhin

Member since: 10/12/2014

860 Reputation

                                      5 Guides authored                  



                       Badges:
                       15







                                                        +12 more badges

Team

                       Cal Poly, Team 6-21, Maness Fall 2014                        

                                                  Member of Cal Poly, Team 6-21, Maness Fall 2014 



                    CPSU-MANESS-F14S6G21                     


                                            4 Members                     


                                            5 Guides authored